Delta ECMS Spindle Motors
Delta ECMS Spindle Motors
Delta ECMS is a family of permanent-magnet spindle motors for CNC machining centres and rigid tapping applications. Delta lists two spindle motor and drive pairings. Both motors have a rated speed of 6,000 rpm and a catalogue maximum of 12,000 rpm. When checking the machine’s spindle speed, include the limits of the tool, holder and spindle assembly.
Motor and ASDA-S drive pairings
ECMS-AM1540AS / ECMS-AM1540BS · 3.7 kW · Delta lists the ASD-S-4523-N drive.
ECMS-AM1570AS / ECMS-AM1570BS · 6.7 kW · Delta lists the ASD-S-5523-N drive.
When selecting a spindle motor, check its mechanical dimensions and speed–torque curve alongside the power rating. Both models are listed with a 155 mm frame, 28 mm shaft diameter and IP55 rating. Verify the motor and drive pairing using the complete codes. Delta lists a three-phase 220 V input supply for both spindle drives.
Both motors use a 17-bit incremental encoder. In rigid tapping, the CNC synchronizes spindle rotation with Z-axis feed. Check encoder feedback, closed-loop behaviour and speed and torque control together.
A and B shaft options
On models ending in AS, A identifies the round shaft. On models ending in BS, B identifies the round shaft designed for through-spindle coolant. On a B configuration, check the rotary union and seals along with the coolant channels in the cutting tool. Assess the coolant path with the spindle accessories and check motor thermal management against the motor’s installation conditions.
Editor’s Note
1. Ask for photos of the motor nameplate and shaft end. The AS/BS suffix should be visible alongside AM1540 or AM1570. For a through-spindle coolant system, request a photo of the connection and a record of the leak check.
2. Check runout as well as bearing noise. During a used motor inspection, record bearing noise, shaft play and measured runout separately. For machining accuracy, compare the measurement point with the machine’s maintenance record.
3. Confirm the AM1570 torque curve. Delta’s catalogue table and curve show different rated torque figures. For continuous-load calculations, give Delta the exact motor code and operating speed and confirm which curve applies.
4. Check encoder connections if speed feedback is unstable. With the machine safely isolated, inspect the motor-side and drive-side connectors. Check grounding, shield termination and signal cable routing against the panel schematic.
5. Record the operating cycle when a stopping fault occurs. Note spindle speed, load and deceleration time. If the fault involves regenerative energy, check the braking resistor and any C-Box hardware against the schematic for the exact ASDA-S model.
6. Ask to see the functions the machine uses. Request a test record showing commanded and actual speed with the machine’s safeguards active. If the machine uses rigid tapping or spindle orientation, ask to see that function in the test. Back up the drive and CNC settings before replacement.
ECMS technical documents
Delta ECMS Spindle Motors — CNC Catalogue (PDF) · English, May 2019, 44 pages. PDF page 32 covers the motor specifications, shaft options, dimensions and speed–torque curves. The ASDA-S drive table is on the following page.
Delta CNC Solution — ECMS and ASDA-S (PDF) · English, August 2017, 3 pages. Shows how the ECMS motor, ASDA-S drive and NC300 controller fit together.
Related Delta equipment
Delta ASDA-S spindle drives · Delta ASDA-A2 axis drives · Delta ECMC motors · Delta ECMA motors · Delta ECML linear motors · Delta ECMR motors
Servo cables · Encoder connectors · Braking resistors · DC bus units · Motion control cards
Delta Servo Manuals · Delta Servo Motors · Used Spindles
External reference — ECMS specifications in the Delta CNC catalogue