Delta ASDA-S

Delta ASDA-S – CNC Spindle Drives

The Delta ASDA-S is a family of drives that control the spindle motor turning the cutting tool or workpiece in a CNC machine. Delta uses it as the spindle drive in its NC300 CNC solution. The three models below are in the three-phase 220 V AC class.

ASD-S-4523-N, ASD-S-5523-N and ASD-S-7523-N

ASD-S-4523-N – 4.5 kW class, 32.5 A RMS continuous output. Delta lists the ECMS-AM1540□S and induction motors within the stated power and current limits. The catalogue specifies built-in regenerative braking.

ASD-S-5523-N – 5.5 kW class, 40 A RMS continuous output. Delta lists the ECMS-AM1570□S and suitable induction motors within the stated limits. The catalogue shows an external braking resistor or the Delta C-BOX ASD-MDCP2016 for braking.

ASD-S-7523-N – 7.5 kW class, 47.5 A RMS continuous output. The catalogue lists suitable induction motors for this model. It shows an external braking resistor or Delta C-BOX for braking.

Motor Matching, Feedback and DMCNET

When selecting a motor, check rated current, operating speed and required continuous torque along with the nameplate kW. Check the torque-speed relationship for both low-speed cutting and high-speed machining. Power and torque describe different aspects of the load.

When matching the drive and motor, check the complete motor code, feedback type, encoder connector and cable code together. For ECMS pairings, also check the catalogue’s incremental encoder specification. On machines that require closed-loop operation and spindle orientation, verify the feedback and CNC settings together. Delta’s NC300 solution uses DMCNET for motion communication between the CNC and the drives.

As the spindle slows, regenerative energy can raise the DC bus voltage. When selecting a braking resistor or C-BOX, check the model’s wiring diagram, stop frequency and required braking torque.

Editor’s Note

Ask for three labels before buying. Get the complete ASD-S-…-N drive code, the full motor code and the CNC controller model. Ask for photos of both ends of the motor and encoder cables. You can then compare the tested assembly with the one in your machine.

Back up the old drive while it can still be read. Save the drive parameters, spindle settings and firmware version if available. For an OEM-specific machine configuration, give the machine builder the exact replacement code and ask them to confirm the fit.

Check the braking hardware on the 5.5 and 7.5 kW units. Ask which resistor or C-BOX the seller used for testing. Record any alarm during deceleration even if the spindle runs normally at steady speed.

Watch command and feedback together during the test. With a matched motor, guards in place and the machine’s service procedure followed, check direction and actual speed at low rpm. Record drive-ready status, speed command, feedback and the orientation result where applicable.

Inspect the cable when an encoder alarm is intermittent. Start with the connector latch, cable shield and grounding connection. If the alarm occurs only during acceleration, examine the power and feedback cable routing for electromagnetic interference.

ASDA-S PDF Files

Delta CNC Solution Catalogue – English PDF. Printed pages 31–32 show ECMS motor pairings, the ASDA-S model table, continuous output currents and braking options.

Introduction to the Delta CNC Solution – English PDF. It explains how NC300, DMCNET, ASDA-S-N and ECMS fit into the CNC system. See Delta Servo Manuals for other documents.

Related Topics and Delta Equipment

Spindle motor selection · Spindle drive selection · CNC machine maintenance

Delta servo drives · Delta servo accessories · Delta PLC · Delta DOP-100 HMI

External reference · Delta CNC Solutions Catalogue, 2024