Delta AH64AN02P-5C

Delta AH64AN02P-5C – 64-Point PNP Transistor Output Module

The Delta AH64AN02P-5C is a 64-point PNP sourcing digital output module for the Delta AH500 PLC rack. An active output supplies positive voltage to a compatible DC load. Two latched 40-pin MIL/IDC connectors route the 64 outputs to field terminals in two 32-point groups. See Delta AH digital modules for other high-density I/O options.

Output voltage and current limits

Delta specifies 12–24 V DC in the wiring diagram. For resistive loads, the limits are 0.1 A per output and 1 A per common. Check the total current when several outputs on the same common are active. The manual specifies an external 24 V DC auxiliary supply at UP/ZP. When planning the cabinet, check both the AH rack power supply and the auxiliary output supply. For coil loads, select a relay interface with suitable load and contact ratings.

Cable and external terminal selection

To route the PNP outputs to field terminals, use a UB-10-OT32A / DVPAETB-OT32A terminal board with a 40-to-40-pin cable. Delta shows the UC-ET010-24A and the catalogue-listed DVPACAB7A10 for this arrangement.

To obtain relay contacts, use the UB-10-OR16B / DVPAETB-OR16B interface with a 40-pin to dual 20-pin cable. Delta shows the UC-ET010-24C or the catalogue-listed DVPACAB7B10. One branched cable routes 32 outputs to two 16-point relay interfaces. See Delta AH I/O cables and Delta AH external terminals for other options.

ISPSoft and output addressing

Use HWCONFIG in ISPSoft to verify the rack, slot and module’s starting Y address. Match each terminal channel to its Y address in the project. The front selector changes which 32-point output group is displayed on the LEDs. See AH expansion modules for rack planning.

Manual and PDF archive

AH64AN02P-5C wiring diagram – AH500 Hardware and Operation Manual (EN) · PDF pages 225–226 cover the module and external terminal wiring. For cable selection, see section 2.2.9 of the Delta PLC/HMI Cable Selection Guide. Other series documents are available under Delta AH PLC PDF files.

Editor's Note

When buying a used module, read the complete label. The P in AH64AN02P-5C identifies the PNP output type.

Inspect both connectors for bent pins or damaged latches. Ask whether the cables and terminal boards are included.

On the bench, test both output groups with a suitable low-current load. When an LED lights, measure the corresponding field terminal as well.

If one group is inactive, check its UP/ZP supply and both cable ends before suspecting the card.

Record the Y addresses and cable orientation before replacement. Before returning the cabinet to service, verify that the first and last outputs reach the intended field points.

Related models and topics

The AH64AN02T-5C provides 64 NPN sinking outputs. The AH32AN02P-5C provides 32 PNP outputs with a MIL connector, while the AH32AN02P-5B provides 32 PNP outputs with a DB37 connector. See the AH16AN01P-5A for racks that need fewer outputs.

The AH64AM10N-5C is a 64-point digital input module in the same family. For Derell PLC projects, see Derell DLC expansion modules.

Delta AH PLC series · Delta PLC · Second-hand Delta equipment

External reference

Delta Electronics PLC/HMI Cable Selection Guide (EN)