Delta AH32AN02T-5C

Delta AH32AN02T-5C | 32-Channel NPN Digital Output Module

The Delta AH32AN02T-5C is a 32-channel NPN transistor output module for the Delta AH500 PLC rack. Its sinking outputs conduct load current toward 0 V when active. The 40-pin latching MIL/IDC connector supports field wiring through a cable and an external terminal board.

Output ratings and field supply

Delta’s wiring diagram for this model shows a 12–24 V DC output circuit. For resistive loads, the hardware manual specifies 100 mA per channel and 1 A total per common. The UP and ZP terminals are for the 24 V DC auxiliary supply. In a sinking circuit, the load sits between the positive supply and the corresponding Y output.

Delta specifies a maximum switching frequency of 100 Hz for resistive loads and a response time of 0.5 ms in either direction. PLC scan time also affects switching in the application. For inductive loads such as contactor coils, select an external interface rated for the load type and current. Compare other AH digital modules when selecting the hardware.

Cables, external terminals and ISPSoft addressing

Delta’s cable selection guide shows the UC-ET010-24A straight cable for the UB-10-OT32A terminal board. The UC-ET010-24C branch cable is one option for configurations using two UB-10-OR16A relay terminal boards. Check the pin arrangement in the AH I/O cable and AH external terminal references before ordering.

HWCONFIG in ISPSoft assigns two consecutive 16-bit Y groups. For example, if the start address is Y2.0, the two groups are Y2.0–Y2.15 and Y3.0–Y3.15. Read the actual assignment from the rack project. See Delta PLC software for the engineering tools.

Manuals and PDF downloads

AH500 Hardware and Operation Manual — PDF · English · 2023-04-12 · 678 pages. See printed page 2-31 for ratings, 4-47 and 4-48 for module and terminal wiring, and 5-13 for Y addressing.

Delta PLC/HMI Cable Selection Guide — PDF · English. Section 2.2.6 covers cable and terminal combinations for the AH32AN02T-5C. More series documentation is available in the Delta AH PLC PDF library.

Editor's Note

When buying a used module, check the full AH32AN02T-5C part number and inspect the connector latch and pins.

Before removal, record the connector orientation, terminal board code and Y start address in HWCONFIG.

If an output LED is on and the load stays off, check the UP/ZP auxiliary supply and the return path at the terminal board.

If an entire group stops working, start by checking the cable, connector and common connection for that group.

On the bench, use a suitable low-current resistive test load to check outputs in both groups. Compare the measured output under load with the LED indication.

Related topics

The AH32AN02T-5A uses a removable terminal block and the AH32AN02T-5B uses a DB37 connector. Both have 32 NPN outputs. The AH32AN02P-5C is the 32-channel PNP sourcing model. Other channel counts include the 64-channel AH64AN02T-5C and 16-channel AH16AN01T-5A.

More from OtomasyonAVM
AH expansion modules · Delta AH PLC series · Delta PLC accessories · Delta PLC · Used Delta equipment

External reference
Delta Electronics AH500 manual — distributor copy