Delta AS-F232

Delta AS-F232 RS-232 communication card

The Delta AS-F232 is a function card that adds one RS-232 serial port to a compatible Delta AS300 CPU. Its female DB9 port supports point-to-point communication with a compatible HMI, instrument or computer. The PLC can operate as master or slave, depending on the application.

Compatible CPUs and card slots

On an AS300 CPU, install the card in function card slot 1 or 2. These slots are available on the AS332T-A, AS332P-A, AS324MT-A, AS320T-B, AS320P-B and AS300N-A. When installed in an AS00SCM-A, the host module must be in COM mode. The AS200 CPU has no direct slot for this card.

DB9 pinout and cable selection

On the card, pin 2 is TX, pin 3 is RX and pin 5 is GND. Check the TX and RX directions in the other device’s wiring diagram. The card’s TX connects to the other device’s RX, and the card’s RX connects to the other device’s TX. Choose a straight-through or crossover cable based on the pinout at both ends. Delta PLC cable guide

ISPSoft and Modbus settings

Open the PC-to-CPU connection in COMMGR. In ISPSoft, open HWCONFIG. If the card is installed in the CPU, select Function Card 1 Setting or Function Card 2 Setting for the occupied slot. Match the baud rate, data bits, parity and stop bits at both ends. For Modbus, also check the RTU or ASCII mode and the device address. On an AS00SCM-A, check the ID and FORMAT settings for the occupied slot.

Other AS communication cards

The AS-F422 provides RS-422 and the AS-F485 provides RS-485. The AS-FCOPM is for CANopen, the AS-FEN02 is for Ethernet and the AS-FPFN02 is for PROFINET.

Editor’s Note

When buying a used card, check that the label reads AS-F232 and the DB9 connector is undamaged.

Save the PLC project, slot position and serial settings before removing the card.

Disconnect power before installation. On the first check, confirm that HWCONFIG shows the card in the correct slot.

If communication fails, check TX, RX and GND continuity with power disconnected. Then check the baud rate, parity and protocol settings.

Start the bench test with one connected device and a known data request. After receiving a response, test the field connection.

Related topics

Delta AS PLC series · AS expansion modules · Delta PLC software · Delta PLC home · Used Delta products · Delta PLC and HMI manuals

Manufacturer references

AS-F232 installation and pinout sheet (includes EN) · AS hardware manual (EN) · AS series catalog (EN) · ISPSoft manual (EN)