Delta AS-FCOPM

Delta AS-FCOPM CANopen Function Card

The Delta AS-FCOPM is a CANopen communication card for the Card 2 slot of a Delta AS300 CPU. It exchanges data with compatible servo drives and remote I/O stations. In CANopen DS301 mode, the PLC can operate as a master or slave. Delta specifies up to 64 slave stations in master mode.

CPU compatibility and wiring

Delta’s manual lists the AS300N-A, AS320T-B, AS320P-B, AS332T-A, AS332P-A and AS324MT-A. The card requires a vacant Card 2 slot. AS200 CPUs have a built-in CAN port.

The card’s RJ45-style CAN connector uses pin 1 for CAN_H, pin 2 for CAN_L and pin 3 for GND. Use shielded CAN cable and terminate both physical ends of the bus with 120 Ω. Enable the card’s built-in resistor if it sits at an end of the bus. Cable length depends on the CAN bit rate. Delta lists maximum distances of 500 m at 125 kbit/s and 25 m at 1 Mbit/s.

ISPSoft and CANopen Builder setup

In ISPSoft, select AS-FCOPM under Function Card 2 in HWCONFIG. COMMGR manages the PC-to-PLC connection. When configuring a DS301 network in CANopen Builder, check the node IDs, common bit rate and PDO mappings. With an AS00SCM-A remote I/O station, check the operating mode on both the PLC and the station.

Select the card for the network protocol. The AS-F485 handles RS-485 serial communication, the AS-FEN02 handles Ethernet and the AS-FPFN02 handles PROFINET.

Editor’s Note
When buying used, inspect the label, the latch and the RJ45 contacts.
Isolate power to the CPU and expansion group before fitting or removing the card.
Record the node IDs, bit rate and PDO mappings before a replacement.
If communication drops intermittently, check termination at both ends and inspect the shielded cable.
Verify data exchange with one node on the bench first. Then add the remaining stations one at a time.

Related topics

AS function cards · AS expansion modules · Delta PLC and HMI manuals

Delta AS PLC series · Delta PLC · Used Delta equipment

Manufacturer documentation · AS Hardware and Operation Manual (EN), Chapter 10 · AS-FCOPM instruction sheet (includes EN)