Delta AS32AN02T-A
Delta AS32AN02T-A 32-channel NPN digital output module
The Delta AS32AN02T-A is a 32-channel NPN sinking transistor output module in the Delta AS digital module range. A 40-pin MIL connector carries the DC control signals to an external panel terminal block.
Output ratings and load selection
The output load circuit is rated for 5–30 V DC. Delta specifies 0.1 A per output and 3.2 A per common for resistive loads. The maximum switching frequency for a resistive load is 100 Hz. PLC scan time affects the rate achieved in the application. Select a suitable protected output interface for inductive loads.
MIL cable and external terminal
Delta’s example for the UB-10-OT32A uses a shielded 40-pin to 40-pin cable such as the UC-ET030-24B. The UC-ET030-24D has a 40-pin to dual 20-pin layout. When selecting an external terminal, check both cable ends and the C0 common shown in the AS wiring diagram.
PLC addressing and model differences
Verify the CPU model and module order in an AS200 or AS300 project. Read the output addresses in HWCONFIG in ISPSoft. Connect to the CPU through COMMGR and compare the addresses against the field labels. Use Delta’s AS mapping table when the terminal carries DVP markings.
The AS32AN02T-B has the same output count with removable spring terminals. The AS32AM10N-A offers 32 digital inputs and the AS64AN02T-A has 64 NPN outputs. For 16 channels, the AS16AN01T-A uses NPN, the AS16AN01P-A uses PNP and the AS16AN01R-A uses relay outputs.
PDFs and wiring diagrams
The general AS manual is listed as D06 under OtomasyonAVM PLC accessories files. For the AS32AN02T-A diagram, see Section 2.4.14 of Delta’s module manual and Section 4.7.14 of the hardware manual.
Editor's Note
Check the -A suffix and 40-pin connector in the photos.
Inspect the MIL connector for bent pins, loose latches and corrosion.
Record the HWCONFIG addresses and terminal labels before replacing the module.
If the output LED is on and the load stays off, check the DC field supply, C0 return and cable in sequence.
For a used module, test all 32 outputs individually with a suitable resistive load isolated from the machine.
Related topics
AS expansion modules · AS power supplies · PLC and HMI manuals
Delta AS PLC series · Delta PLC main category · Used Delta equipment
External references
Delta AS Module Manual (EN) · Delta AS Hardware and Operation Manual (EN)