Delta AS16AN01R-A
Delta AS16AN01R-A 16-point relay output module
The Delta AS16AN01R-A is a 16-point relay output expansion module in the Delta AS digital module range. It switches suitable interposing relays and signalling circuits in machine control panels. The relay contacts switch the external supply for the field load.
Contact ratings and C0 commons
Delta’s module manual specifies a load voltage of 10–240 V AC or 5–24 V DC. The resistive load limits are 2 A per output and 8 A per common. To check the 8 A limit, add the currents of loads connected to the same common and operating at the same time. The manual lists a maximum switching frequency of 1 Hz for resistive loads and 0.5 Hz for inductive loads.
The removable spring-clamp terminals have outputs 0–15 in two columns. Even numbers are on the left and odd numbers on the right. The upper terminals are marked C0 in the wiring diagram. Check the field supply and common wiring against section 2.4.6 of Delta’s module manual. For coil loads, check the contact life curve and select suitable surge suppression.
PLC connection and output addresses
In an AS200 or AS300 system, the unit mounts alongside the other AS expansion modules. Check the AS power supplies and the field load supply separately when sizing panel power. In ISPSoft, use HWCONFIG to verify the module position and assigned Y output addresses. The 0–15 markings identify local channels on the module.
Connect the PC through the CPU using COMMGR and a suitable Delta PLC cable. See Delta PLC software and PLC accessories for related documentation.
Editor’s Note
When checking a used unit, read the full AS16AN01R-A code on its side label. Several models show 16AN on the front.
With power isolated, check the removable terminals for looseness or heat marks, especially around C0.
Start with a suitable low-voltage test load. When the OUT LED turns on, measure whether the contact actually closes.
If a channel remains conductive after an OFF command, isolate power and disconnect the field wiring before checking for a welded contact.
Before replacing the module, record its order and Y addresses in HWCONFIG. Verify that the same channels operate the same loads on the replacement.
Related models and PDFs
The AS08AN01R-A has eight relay outputs. The AS16AP11R-A has eight digital inputs and eight relay outputs. The AS16AN01T-A uses NPN outputs and the AS16AN01P-A uses PNP outputs. For field inputs, see the AS16AM10N-A.
Delta PLC and HMI manuals · More Delta pages · Delta AS PLC series · Delta PLC main page · Used Delta equipment
External references
Delta AS Module Manual (PDF, EN) · Wiring diagram in section 2.4.6, page 2-29. Delta AS Hardware and Operation Manual (PDF, EN) · Wiring in section 4.7.6.
AS16AN01R-A installation sheet (PDF, EN and TR included) · The sheet lists 250 V AC / 30 V DC. The operating range on this page follows the module manual.