Delta AS06XA-A

Delta AS06XA-A analog input and output module

Delta AS06XA-A is an analog I/O module for Delta AS PLCs with four 16-bit analog inputs and two 12-bit analog outputs. It uses an external 24 V DC supply. Conversion takes 2 ms per channel, or 1 ms per channel with firmware V1.02 or later.

Signal ranges and terminals

Inputs and outputs support ±10 V, 0–10 V, ±5 V, 0–5 V and 1–5 V. Current inputs support ±20, 0–20 and 4–20 mA. Current outputs support 0–20 and 4–20 mA. Choose 0–10 V or 4–20 mA to suit the field device.

For current input, bridge Vn+ and In+ on the same channel. Use VO for voltage output and IO for current output, both with AG as the return. The maximum current output load is 550 Ω.

Channel setup and scaling

In AS200 and AS300 projects, set each channel mode in ISPSoft HWCONFIG. Connect through COMMGR to monitor raw values. Nominal 4–20 mA input values are 4 mA = 0, 12 mA = 16,000, 20 mA = 32,000. For remote I/O with AS00SCM-A, verify network and firmware compatibility.

Editor’s Note

Check the nameplate and removable terminal block when buying used.
Measure the 24 V DC supply.
Check that the jumper is on the intended input channel.
Apply 4 and 20 mA on the bench and check both scale endpoints.
Measure an output with a test load disconnected from the machine.

PDFs and related models

AS PLC PDF files · AS hardware manual (EN)
AS04AD-A · AS04DA-A · AS08AD-B · AS08AD-C
Temperature measurement: AS04RTD-A (RTD) · AS04TC-A (thermocouple)

More Delta pages AS expansion modules · Delta PLC · Used Delta products

External references Installation sheet (TR/EN) · Delta module manual (EN, Chapter 5)