Delta AS08AD-B
Delta AS08AD-B 8-Channel Analog Voltage Input Module
The Delta AS08AD-B is an 8-channel, 16-bit analog voltage input module for compatible AS200 and AS300 PLCs. It reads signals from voltage-output sensors and transmitters.
Voltage ranges and wiring
Each channel can be set to 0–10 V, 0–5 V, 1–5 V, ±5 V or ±10 V. Conversion takes 2 ms per channel, or 1 ms per channel with module firmware V1.02.00 or later. The module uses a removable terminal block and a 24 V DC supply.
For example, wire a 0–10 V sensor to V1+ and V1− on channel 1 using Delta's diagram. Use the diagram for your three- or four-wire transmitter. Route shielded signal cable away from power wiring and check the FE connection.
ISPSoft setup and scaling example
Add the AS08AD-B in its physical position in ISPSoft HWCONFIG. Set each channel's voltage range, data format and averaging filter. Read the input address from the project mapping. Connect the PC to the CPU through COMMGR using Ethernet or the programming cable supported by the CPU.
Example · With a 0–16 bar pressure sensor that outputs 0–10 V and an input scale of 0–32,000 counts, 5 V corresponds to approximately 16,000 counts and 8 bar. Check the raw input online, then compare it with the engineering value on the HMI.
Related Delta modules
The AS08AD-C provides eight current inputs and accepts 4–20 mA sensor signals. The AS04AD-A measures voltage or current on four channels. The AS06XA-A has four analog inputs and two analog outputs. The AS04DA-A provides four analog outputs.
Editor’s Note
On a used unit, check the -B suffix and the removable terminal block.
Compare the sensor's voltage range with the ISPSoft channel setting.
Test in a safe state using one channel and a known voltage.
If the raw reading is correct, check the HMI scaling. If it fluctuates, inspect the cable and shield first.
Before replacing the module, back up the channel settings and record the firmware version.
Related topics · Analog signals · 0–10 V and 4–20 mA · Analog and digital inputs
OtomasyonAVM PDFs · Delta PLC accessory files (AS manual D06)
More Delta pages · AS analog modules · AS expansion modules · Delta AS PLC series
External references · AS08AD-B/C wiring sheet (includes EN and TR) · AS module manual, chapter 3 (EN)