Delta AH analog modules

Delta AH Analog Modules – Input, Output and Mixed I/O

Delta AH analog modules let a Delta AH500 PLC read sensors and send analog commands to field devices. For example, an analog input reads a pressure transmitter, while an analog output sends a speed reference to a drive or a position command to a proportional valve. This category contains four input modules, four output modules and one mixed analog I/O module.

AD Series – Analog Input Modules

The AH04AD-5A has four analog inputs and the AH08AD-5A has eight. Both models have voltage and current input ranges.

The AH08AD-5B has eight voltage inputs. The AH08AD-5C has eight current inputs. Consider the 5B for 0–10 V sensors, the 5C for 4–20 mA transmitters, or the 5A when an eight-channel module needs to handle both signal types.

DA Series – Analog Output Modules

The AH04DA-5A has four analog outputs and the AH08DA-5A has eight. Both models have voltage and current output ranges.

The AH08DA-5B has eight voltage outputs. The AH08DA-5C has eight current outputs. Check the signal type, range and load requirements of the drive or valve input before selecting an output module.

XA Series – Inputs and Outputs on One Module

The AH06XA-5A provides 4 analog inputs and 2 analog outputs on one module. Both sides support voltage and current ranges. In a pump application, the same module can read pressure feedback and send a speed reference to the drive.

Model Selection and ISPSoft Setup

Start with the number of inputs and outputs required. Then check each channel’s operating range, such as 0–10 V or 4–20 mA, along with terminal wiring and power requirements. In HWCONFIG in ISPSoft, verify the full model code, channel mode and I/O addresses. For direct Pt100 or thermocouple wiring, see Delta AH temperature modules.

Editor’s Note

When buying used, read the 5A, 5B or 5C suffix on the module label.

Confirm that the removable terminal block is included and check the condition of its screws.

Apply a known signal to test input modules. Measure output modules with a suitable load connected.

When possible, check a 4–20 mA channel at 4, 12 and 20 mA. On a linear scale, 12 mA is the midpoint.

Record the channel modes, scaling values and I/O addresses before replacing a module.

Manuals and PDF Files

AH500 Hardware and Operation Manual (English). Section 2.7 covers specifications and section 4.9 contains wiring diagrams.

AH500 Module Manual (English). Chapters 2, 3 and 4 cover analog inputs, analog outputs and mixed I/O respectively. See Delta AH PLC PDF files for the full archive.

Related Topics

What is an analog signal? · AH digital modules · AH power supplies · AH expansion modules

Delta AH PLC series · Delta PLC · Delta Automation

External reference · Delta AH500 Hardware and Operation Manual


Refine Search