Delta Servo Modules and Accessories

Delta Servo Modules and Accessories

This category covers motor connections, feedback, control, braking and safety accessories for Delta servo drives. When replacing a part on an existing axis, start with the full drive and motor nameplate codes. Choose the category below for the job you are doing.

Motor and encoder connections

Delta Servo Cables · Assembled motor power and encoder cables. Compare cable length, both connector ends and the motor brake option.

Delta Servo Power Connectors · Plugs and sockets for motor power wiring. On braked motors, verify the brake contacts and connector drawing for the exact motor code.

Delta Encoder Connectors · For a motor-side or drive-side encoder connector, check housing, pin arrangement and locking mechanism.

Delta Encoder Signal Converters · Units that adapt an external linear scale or encoder signal in compatible ASDA-A2R applications. Check the input signal and drive connection for the ASD-IF-EN0A20.

Delta Absolute Encoder Peripheral Units · Battery boxes and leads for absolute encoders. Verify the battery connection in the diagram for the drive and motor series.

Control and communications

Delta Servo I/O Connections · CN1 connectors, terminal block modules, digital I/O and pulse and direction connections. See the series table for the ASD-CNSC0050 connector and ASD-BM-50A terminal block module.

Delta Servo Communication Units · PC cables, serial communication connectors and CANopen distribution units such as the TAP-CN03. Verify the port and protocol for the exact drive code.

Delta Servo Operator Panel Cables · External keypad connections. Delta lists the ASDBCADK0001, for example, between ASDA-B CN3 and the ASD-PU-01A/01B keypad.

Delta Motion Control Cards · EtherCAT or DMCNET cards for PC-based multi-axis control. Check the card slot, drive protocol and software environment together.

Energy and safety

Delta DC Bus Units · DC bus units and C-Box documentation for compatible multi-axis systems. Use the manufacturer’s system diagram and approved drive combinations for bus connections.

Delta Servo Braking Resistors · Resistance and wattage for braking resistors such as the BR400W040. Check the drive’s minimum resistance and the machine’s regenerative braking duty cycle together.

Delta Servo STO Connections · Safety connectors and manufacturer wiring diagrams for drives with Safe Torque Off. Verify electrical isolation separately before servicing.

Editor’s Note

Inspect both cable ends when buying used. Ask for the part label, cable length and clear photos of both connectors and their latches. A bench inspection can reveal crushed insulation, backed-out pins and shield damage before installation.

Record where an encoder fault occurs. If the fault repeats at the same cable-carrier position, inspect the moving cable and connector latch. If it appears at higher motor current, also assess cable routing and signal noise. Confirm the meaning of the alarm in the manual for that drive.

Save the settings before replacing a control cable. Record I/O assignments, command format and the electronic gearing ratio. After replacement, compare measured movement with a known distance. If the motor or drive also changes, verify the motor and drive combination again.

Read braking alarms in the context of the duty cycle. The A2, B2 and A3 manuals list AL002 as overvoltage and AL005 as a regeneration error. Record whether the alarm occurs at power-up, during a rapid stop or after repeated stops. Compare the drive table, resistor label and parameter record together.

Secure vertical loads before working on an STO circuit. STO removes motor torque. Before service, isolate power, verify DC bus discharge as specified in the manual and support the vertical load mechanically.

Related topics

Motion and position control · Speed loop gain · Torque control · Servo control loops · Load and transmission calculations · Supervisory servo control

Delta drives, motors and PDF archive

Delta Servo Drives · Delta Servo Motors · Delta Servo PDF Archive

Delta reference documents · ASDA-A2 accessory catalog (EN) · ASDA-A3 wiring and STO manual (EN)


Refine Search