Delta AH motion controllers

Delta AH Motion Controllers

Delta AH motion controllers manage servo axes over EtherCAT in the Delta AH PLC family. The built-in 100 Mbps EtherCAT master connects compatible servo drives and field I/O to the same network. Typical applications include packaging, cutting, feeding and multi-axis positioning.

Choose by axis count

Delta AH08EMC-5A · Up to 8 physical axes. The entry model for compact machines and stations with fewer axes.

Delta AH10EMC-5A · Up to 16 physical axes. For machines that combine several stations under one controller.

Delta AH20EMC-5A · Up to 32 physical axes. For lines that need more axes on one controller.

Delta lists minimum EtherCAT synchronisation times of 0.5 ms, 1 ms and 2 ms at 8, 16 and 32 axes, respectively. Check the required cycle time alongside the selected drives and field I/O devices.

Backplane, cabling and software

For use as the main CPU, choose an AH Motion M2 backplane. Compare the AHBP03M2-5A, AHBP05M2-5A and AHBP07M2-5A by the number of modules required. Select an AH power supply sized for the rack load.

Use EtherCAT cables for the drive network. For CN1 field I/O, Delta specifies the UC-ET010-13B cable and the UB-10-IO22C terminal board. See Delta external terminals for wiring accessories.

Use ISPSoft for programming and hardware configuration. Connect the PC through COMMGR using Ethernet or Mini USB. Check the backplane layout, EtherCAT device order and axis assignments against the project.

PDF documents The AH Motion Hardware Manual (English, 2016) covers backplanes, ports and wiring. See the Delta AH catalogue for model and accessory selection and Delta AH PLC PDF Files for further documentation.

Editor’s Note

Start by counting the physical servo axes on the machine. Allow for any stations planned for later.

On a used controller, verify the full order code and inspect the EtherCAT socket, CN1 and rear backplane connector.

Check whether the backplane, power supply, CN1 cable and field terminal are included.

Before replacement, back up the ISPSoft project and record drive order, axis assignments and firmware versions.

For the first move, use a safe test setup and run one axis at low speed. Verify direction, homing and limit signals individually.

Related Topics

Delta AH500 CPUs · AH expansion modules · Delta PLC software · Delta PLC accessory files · Delta PLC · Second-hand Delta products

External References

Delta AH Motion Operation Manual (2023) · Delta AH Motion Hardware Manual (2024)


Refine Search