6ES5 701-3LH11

6ES5 701-3LH11 Siemens SIMATIC S5-115H ER 701-3LH Expansion Rack

The Siemens 6ES5 701-3LH11 is the ER 701-3LH expansion rack for switched I/O in a SIMATIC S5-115H. This SIMATIC S5 configuration lets either central controller access the same group of I/O over its own link. In the S5 rack range, the 3LH version is the one designed for this arrangement with CPU 942H central controllers.

Slot layout and module selection

Slots 0 through 5 take up to six compatible digital input, digital output, combined digital I/O or analog I/O modules. Siemens excludes 434-7 series digital input modules from these slots.

Check the Siemens slot and power supply tables before installing communications processors or intelligent I/O and function modules. The CP 524, for example, requires a supply other than the 3 A version.

The PS slot takes a PS 951 power supply and the IM slot takes the IM 306 for I/O addressing. Both are required. The 6ES5 951-7LB21 is a 3 A PS 951 variant. Select the supply to suit the installed modules and their current draw.

Wiring and troubleshooting

In switched I/O operation, slots 6 and 7 hold two IM 314R modules (6ES5 314-3UR11). Each connects to an IM 304 in its respective central controller. Check each link when selecting S5 interface modules and S5 connecting cables. Siemens specifies a maximum of 600 m from the central controller to the last expansion unit for this configuration. The 721-0BC00 is one 2 m cable in the 721 range. Fit a 6ES5 760-0HA11 terminator to the lower front connector on the last IM 314R in each chain.

If the IM 314R shows BF, identify the affected link, then check its cable, termination and expansion unit number set on S1. Both IM 314R modules in a rack must have the same unit number. For backplane checks, use the exact rack pin assignments in Appendix C.7 of the manual.

Read the full 3LH11 suffix on the label. The ER 701-3LA13 and ER 701-2LA11 serve different expansion layouts. The CR 700-3LA12 is an example of a central controller rack.

Editor’s note When buying a used rack, ask for close-up photos of the backplane connectors in slots 6 and 7. Check for corrosion, bent pins and loose guides. Ask which slots and which of the two IM 314R links were tested.

To offer a rack for sale, send the full part number, a backplane photo and any test results to otomasyonavm@gmail.com.

PDF and pin assignments

Siemens S5-115H manual, edition 03 (English PDF). See Figure 3-10 for the rack layout, §3.4.6 for the two IM 314R links and Appendix C.7 for the backplane pin assignments. S5-115 PDF archive.

Related topics

ER 701-2LA12 · ER 701-1LA12 · 6ES5 460-7LA13 analog input · About Siemens S5 PLC

Navigation

S5 Racks · S5 Modules · SIMATIC S5 · Second-hand Siemens · Second-hand automation

Sources

Siemens ST 50 (1998), p. 3/71 · Siemens S5-115H manual, 6ES5 998-0UH21