6ES5 701-3LA13
Siemens 6ES5 701-3LA13 ER 701-3 expansion rack
The 6ES5 701-3LA13 is the ER 701-3 rack for building an EU 3 expansion unit in a SIMATIC S5-115U system. Its aluminium chassis carries the backplane that connects the expansion modules. In the SIMATIC S5 range, the EU 3 slot layout identifies this rack type. The catalogue gives chassis dimensions of 483 × 303 × 47 mm (W × H × D).
The CR 700-3 is the central rack that houses the CPU. The ER 701-3 is used on the expansion side. If you are comparing it with an ER 701-2 or an ER 701-1, check the backplane, slot assignments and connection layout for each model.
S5-115U slots and interfaces
The Siemens ST 50 catalogue shows slots 0–6 for standard I/O modules. In an IM 314 or IM 318 layout, slot 7 takes the link interface. The PS slot takes a PS 951 power supply, and the IM slot takes the IM 306 used to set addresses for block-type I/O. A separate interface module connects the expansion unit to the central controller.
One wired distributed layout uses IM 304 at the central controller and IM 314 at the ER 701-3. It uses a 721-series connecting cable and a 6ES5 760-1AA11 terminator on the last IM 314. Match the installed cables and connectors to the panel drawing.
Check the full part number and permitted slot for digital input, digital output, combined digital I/O and analogue modules. The catalogue lists the 6ES5 466-3LA11 as an example of a compact analogue input module. For communications processors and positioning modules, consult the Siemens slot table for adapter requirements.
For hardware interrupts in the S5-115U expansion unit, Siemens specifies the IM 307, 6ES5 307-3UA11 and IM 317, 6ES5 317-3UA11 fibre-optic pair. The IP 241 K manual shows slots 0–6 for interrupt operation in this configuration.
S5-115F use. Siemens lists the same order number for this family. The expansion rack’s PS slot is left empty in the centralised layout. Distributed operation requires its own power supply. Siemens excludes hardware interrupt evaluation on S5-115F expansion units.
What to check on a used rack
Check the 3LA13 suffix on the label, the backplane connectors, the card guides and the mounting ears. If the offer includes PS or IM modules, confirm the full order number of each one.
Editor’s note
If a single card drops out, start with its slot and connector. If the entire S5-115U expansion unit drops out, inspect the PS 951 and the interface link to the central controller before replacing the rack.
To offer a rack for sale, send photos of the label and backplane to otomasyonavm@gmail.com.
PDFs and Siemens references
Siemens ST 50 catalogue, pp. 3/66 and 3/76 (EN) · S5-115U manual, Figure 3-12 (EN) · IP 241 K manual, p. 8-4 (EN).
Related topics
About Siemens S5 PLCs · 6ES5 701-3LH11 rack for S5-115H · CP 524 communications processor
Used Siemens · S5 racks · CPU 90U–115U · Siemens S5 · Used Siemens main page