6ES5 256-3AA11

Siemens 6ES5 256-3AA11 AS 256 DIMOS Interface

The Siemens 6ES5 256-3AA11 is the German-language AS 256 display interface for DIMOS diagnostics and monitoring. Also listed as VISRAM 256, it brings diagnostic information from the SIMATIC S5 controller to a monitor. Identify the CPU and system model before selecting a spare.

Display connection and DIMOS diagnostics

In Siemens catalog ST 53, BAS is the VISRAM connection to the monitor. The ADEGIS listing for 3AA11 specifies one BAS interface, two serial interfaces and 1.3 A at 5 V. These figures come from the supplier. Compare the S5 cable types with the cabinet drawings and verify the serial pinout and electrical standard against the installation documentation.

With the DIMOS function blocks loaded and configured, a stalled sequence can display the sequence number, step number and unmet transition condition. Compare that condition with the program and the field signal at the S5 digital input module, such as the 420-4UA11 input card. Check the load driven by a 441-4UA14 output card separately when relevant.

Parts listings place 3AA11 in the S5-135/155 group. A CPU 928B or CPU 948 label identifies the processor. Record the installed rack separately. The 188-3UA21 central unit, 183-3UA12 expansion unit and 955-3LF12 power supply have separate part numbers.

The Siemens S5-115U manual shows DIMOS-VISRAM adapter casings and slot layouts for racks such as the CR 700-0LB11. This is family-level information. In a 115U installation with a CPU 944, check the installed card number, casing and slot together.

Service listings identify 6ES5 256-3AB11 as a later order number. Match the monitor, cable and DIMOS project before changing versions. The IP 255 MONA C, CP 526 and CP 526-2 basic board are separate display products.

Sort S5 interface modules by function when documenting the rack. The CP 530 serves SINEC L1 and the CP 535 serves SINEC H1. On the AS 256 side, treat the monitor connection and the DIMOS project as separate points to check.

Editor’s note

Before buying, ask for a photo of the 3AA11 order number and hardware revision. Record the German DIMOS version used in the installation.

Label the rack, slot, adapter casing and cables before removing the card. Retain the DIMOS function blocks and message data in the STEP 5 backup.

If the screen is blank, check the monitor’s own power supply and the existing BAS video cable first. Isolate cabinet power before reseating the card.

If the display works but the step or fault message is wrong, compare the DIMOS block parameters and messages with the existing project backup.

Test a used card in a compatible DIMOS setup with a visible display and a sample message. Record the monitor, cable and card order number used.

PDFs and sources

+ Siemens ST 53 · DIMOS/VISRAM, printed page 6/14 · German

+ Siemens S5-115U manual · Figure 3-3, rack configuration · English

+ ADEGIS · 6ES5 256-3AA11 part and interface listing

The Siemens documents cover the DIMOS family and example rack layouts. A pinout and address table specific to the 3AA11 remain unverified.

+ Other SIMATIC S5 PDF files

Related topics

+ S5-210 CRT interface

+ S5-210 serial interface

+ SIMATIC S5 CP 525

Used Siemens equipment

+ SIMATIC S5 special modules

+ Siemens SIMATIC S5

+ Used Siemens equipment

+ Used automation equipment

If you have this card to sell, email a label photo, quantity and known condition to otomasyonavm@gmail.com.