6ES5 981-0HA21

Siemens 6ES5 981-0HA21 | SIMATIC S5 fan unit for long racks

The Siemens 6ES5 981-0HA21 is a 24 V DC twin-fan assembly that fits beneath long SIMATIC S5 mounting racks. It moves air across the installed modules and signals fan failure through a volt-free changeover contact. Siemens documents this model for the S5-115U and S5-115H. The S5 CPU family page helps identify the installed controller.

Supply and dimensions

Rated supply is 24 V DC, with a 20–30 V DC range including ripple and a typical current draw of 800 mA. The assembly measures 423 × 110 × 135 mm (W × H × D), weighs 1.5 kg and has an IP20 rating.

Rack fit and mounting hardware

Two brackets support the assembly below the rack. The bracket and cable duct kit is 6ES5 981-0GA11, and the filter mat unit is 6ES5 981-0JA11. When comparing CR 700-1, CR 700-2 and CR 700-3 racks, confirm the exact order number, bracket positions and clearance underneath.

Check the available width separately on the narrower CR 700-0LA and CR 700-0LB racks. The 6ES5 981-0HB21 listed in the same Siemens table is the 294 mm version with a 24 V DC supply.

For a fan fitted beneath an expansion rack, use the nameplate to distinguish the ER 701-1, ER 701-2 and ER 701-3. If the system uses an IM 306 interface, check the cabinet drawings to find the rack that houses the I/O module monitoring the fan alarm.

Power wiring and fault monitoring

Siemens specifies fan cooling when the load on certain S5 power supplies, including the PS 951-7LD21 and PS 951-7ND41, exceeds 7 A or when high-consumption modules such as certain communications processors are installed. The Siemens wiring diagram shows a 1 A time-delay fuse for the 24 V DC supply on L+ and M. The same-width 6ES5 981-0HA11 uses a 115/230 V AC supply.

During normal operation, 1–2 is closed and 1–3 is open. The contact changes state on fan failure. At 30 V DC, the contact is rated for 2.5 A resistive or 0.5 A inductive loads. When tracing an alarm, use the cabinet schematic to distinguish the S5 interface modules from the fan’s supply and alarm circuits. See S5 cables and connectors when identifying existing wiring.

Checks for a used assembly

Look for the 0HA21 suffix on the nameplate. Check that both motors start, listen for bearing noise, check airflow and verify the alarm contact. Ask about the filter, brackets and cable duct separately. Siemens lists the 6ES5 988-7NA11 replacement kit for replacing a single fan motor.

Editor’s note
One motor can keep moving air after the other stops. During a bench test, check each fan individually and measure the state of the fault contact.

Siemens manuals and PDF archive

See S5-115U page 15-68 for specifications and Figure 3-29 for wiring. For S5-115H, see Figure 3-36 and page 17-63. The accessory codes follow the S5-115U table and the maintenance sections. Siemens S5 PDF archive.

Related topics

About Siemens S5 PLCs · S5-115U CPU 945 · ES 902 adapter casing

Second-hand Siemens

S5 mounting racks · SIMATIC S5 · Siemens S5 PLCs · Second-hand Siemens equipment

Siemens manuals (English)

S5-115U manual · S5-115H manual · CPU 945 manual