Yaskawa Servo Files

A Yaskawa servo axis brings together a motion controller, SERVOPACK, motor and feedback hardware. The first step in servicing an older machine is to identify which part of that chain needs attention. This guide separates drives, rotary and linear motors, connection parts and software so the right question leads to the right family.

Read the axis before choosing a part

A motion fault does not tell you that “the servo” is one failed part. The controller may not be sending a target; the SERVOPACK may be in alarm; a running motor may still be held back by feedback or mechanics. Locate the stage where expected motion stops before following a model family.

Even a drive and motor from the same Sigma generation are not automatically a complete match. Supply, command interface, encoder, cabling and software release matter together. These sections treat the equipment as parts of a working axis, not isolated boxes.

From a fault report to the right page

If the controller issues a move but the axis stays still, start with the drive alarm and then the motor feedback state. If the motor turns while the table does not, the next suspect may be mechanical transmission rather than servo tuning. That distinction prevents a misplaced parts order and points to the right manual.

Where to start

For drive generations, compare the document scope in SERVOPACK drive manuals; use servo motor manuals separately for motor codes and feedback.

What matters in selection

For a failed axis, record the drive alarm, motor nameplate and controller project separately. A shared brand does not make those parts interchangeable; identify the role of the component before choosing a branch of this guide.

The often-overlooked feedback path is examined under Yaskawa Encoder / Terminal / Cable when tracing an axis fault.


Refine Search