Yaskawa Motion Control Systems
The motion controller sets axis targets and timing; the SERVOPACK controls motor power. Network architecture, axis count and programming environment determine the controller side of the system. This branch separates servo-connected controllers from logic functions hosted in a drive.
Where controller work ends and drive work begins
A motion controller can coordinate axis sequence, synchronisation and the machine application. The servo drive turns its command into motor current and processes feedback. Keeping those roles distinct prevents a “parameter backup” from being mistaken for a backup of the controller program.
In service, retain the controller project, network-node configuration and each drive parameter set separately. A change in network generation or axis ordering can alter motion even when the project file opens. Test direction, limits and stopping behavior under the machine procedure after changes.
Why one file is rarely a complete backup
In a multi-axis machine, the controller project defines sequence while each drive retains electrical and tuning parameters. Saving the controller program without drive settings—or drive settings without axis order—leaves gaps. A useful service package also records software release, network topology and the identity of every axis.
Where to start
What matters in selection
A controller replacement depends on servo-network generation, programming environment and project backup as well as axis count. A drive parameter file does not replace the controller application.
The controller project and its place on the servo network are developed in Yaskawa Servo Motion Controllers.