Yaskawa Servo Motion Controllers

A controller manages axis motion and application logic; it does not replace the servo drive. MotionWorks IEC is linked only to the documented MP2600iec path.

Why a project backup differs from drive parameters

A motion controller can hold axis sequencing, speed profiles and reactions to machine events in an application project. Servo-drive parameters describe how one connected motor operates. Retain both backups; sound replacement hardware may still fail to run the original machine cycle without the application.

MP940 and MP2600iec belong to different generations and software environments. Inspect controller network, firmware and project files before planning any migration under a generic “Yaskawa controller” label.

What matters in selection

Before replacing a controller, back up axis parameters and application logic separately. MP940 and MP2600iec differ in networking, axis scope and programming environment; a box code alone is not the application.

Examine the MP2600iec project environment through Yaskawa MotionWorks IEC rather than treating it as ordinary drive-parameter software.

Technical references: MotionSuite MP940 1.5 Axis Controller Brochure; MP2600iec official technical FAQ; Legacy servo product transition notice PA.MCD.07.

Models and technical distinctions

Model / frameDocumented distinction
MP940Sigma II-linked 1.5-axis motion controller associated with the legacy MotionSuite architecture.
MP2600iec / SGDV-OCC02AIEC motion-control option mounted with a servo system; documented with MotionWorks IEC.
SMC-3010Legacy motion controller identified in the 2011 migration notice; confirm its axis and network configuration.
SMC-4000Legacy motion controller identified in the 2011 migration notice; confirm its axis and network configuration.

What works with this component?