GD12 / Goodrive12
INVT GD12 / Goodrive12 veneer peeling lathe drive
The INVT Goodrive12 (GD12) is an AC variable frequency drive for lathes that turn logs into thin sheets of wood veneer. Based on the Goodrive300 (GD300) platform, the GD12 handles machine-specific functions such as knife feed and cutting the veneer to length. The GD12 supplement documents the settings for these functions.
Knife feed and veneer thickness
An encoder on the feed-screw axis measures knife carriage travel. The drive uses that movement to estimate current log diameter and adjust feed speed accordingly. Roller diameter and centre distance, screw pitch, mechanical ratio and the encoder’s pulse count all affect the feed calculation. When replacing a drive, check the incremental encoder resolution and output signal type against the encoder label.
P18.03 and P18.04 are for drive roller diameter and centre distance. P18.09 sets feed pitch, P18.21 the transmission ratio and P18.22 the encoder pulse count. Look at P18.08 for a measured thickness offset and P18.14 for a recurring cut-length error. P18.07 provides length compensation for the last piece. If only the last sheet appears short, measure the regular sheets as well. Those readings show which setting to investigate.
Model code, inputs and commissioning
In GD12-5R5G-4, 5R5 denotes 5.5 kW, G a constant-torque load and 4 the three-phase 380–440 V class. The code table uses -2 for three-phase 220–240 V and -6 for three-phase 520–690 V. When selecting a drive, compare the full nameplate code, motor rated current and rated frequency. The supplement lists sensorless vector and SVPWM modes for basic motor control. Motor autotuning and setting the knife carriage origin are separate operations.
The sample GD12 diagram shows separate functions for fast feed and retract, origin reset, thickness and length selection, and forward and reverse travel limits. When replacing a panel, check the digital input wiring type, analogue inputs and encoder cable shielding. If interference is suspected, review cable routing, earthing and the EMC filter together.
Software, PDFs and fault finding
The supplement shows a text display and an RS-485 connection. Back up the panel project and record the installed devices’ addresses and port settings for RS-485 communication. Before using a tool such as INVT Studio from INVT VFD Software, confirm support for the specific GD12 firmware and panel model. See INVT VFD Documents and INVT fault codes for the broader references.
For drive faults, record both the displayed code and the stage of the cycle when it appeared. If it happens during deceleration, review the stop ramp, DC bus behaviour and model-specific braking resistor arrangement. Verify compatible braking units and resistors in the manual for the installed rating.
Editor’s Note
Buying a used GD12? A photo of the lit keypad tells you very little. Ask for the full nameplate, the drive parameters and a copy of the text-display project if available.
If the displayed diameter moves the wrong way as the knife carriage advances, have the encoder direction and position scaling checked before changing the compensation settings.
If thickness is consistently off target, measure it in several places. If the error changes as the log gets smaller, recheck screw pitch, transmission ratio and roller dimensions.
Have qualified personnel perform the first movement checks under the machine’s safe-test procedure. Keep guards in place and keep the travel limits in circuit.
Before a factory reset, record the working P18 settings, sensor assignments and origin measurement. Those records give you a starting point the next time a fault occurs.
Related topics
Technical guides to vector control, closed-loop control and Modbus RTU. For other control components, see INVT PLC and INVT HMI.
INVT category path INVT brand home › INVT user manuals › INVT VFD drives
Manuals and external references
INVT Goodrive12 veneer peeling lathe supplement V1.0, English PDF · GD12 P18 parameter table · INVT Goodrive300 base drive manual V3.6, English PDF