What is Auto-tune for servo motor?

Automatic servo tuning and motion response

What is servo autotuning?

Servo autotuning helps a servo drive match its control settings to the connected motor and machine. The goal is useful motion: a servo motor that follows commands, avoids excessive ringing and settles within the time the process allows. Tuning changes the response of the system; it does not increase the motor’s physical power rating.

What does the drive identify and adjust?

Depending on the method, the drive applies test movements or excitation signals and evaluates encoder feedback and motor current. It may identify load inertia, mechanical response and resonances. The load and transmission calculation and any gearbox matter because they affect the load reflected to the motor.

There is more to tuning than selecting P, I and D terms. Available tools may adjust velocity-loop gains, position gain, feedforward and resonance filters. Servo loops do not universally use PID; P and PI structures are common. The active position, speed or torque mode also affects what needs tuning. Filters can reduce some mechanical vibration, but cannot repair loose hardware.

Read the response, not just the completion message

The dashed line below marks the target position. The red response overshoots and rings around it. The blue response overshoots less and settles earlier. For position control, reaching the neighbourhood of the target quickly is only part of the job: overshoot, settling time and following error all matter.

Two servo responses to the same target The dashed line is the target position. The red response overshoots and oscillates. The blue response has less overshoot and settles sooner. These are illustrative curves, not measurements from a motor. Position (%) — target = 100 0 100 150 Target position Command applied Time → Red: larger overshoot and prolonged oscillation. Blue: less overshoot and shorter settling time. Start / replay Stop Illustration only; timing and curves are not product performance data.

Settling time is the time required to enter and remain within the permitted error band. The narrow green band illustrates ±2%; a real machine may use a different tolerance. Achieving high dynamic performance requires an appropriate balance between responsiveness and stability, rather than simply pushing gains higher.

A commissioning test is different from online adaptation

One-time autotuning can calculate and save settings after a commissioning test. Online adaptation or a tuning-less function may adjust selected behaviour during operation on drives that support it. An autotune feature does not imply that every setting is continuously updated. The capabilities and operating conditions are specific to the drive.

Prepare the axis before running the test

Confirm the motor model, feedback type, motion direction and mechanical connections. Since tuning may move the axis, establish the available travel, speed and torque limits, and a means of stopping it. A vertical axis also needs appropriate load holding and brake sequencing. Correct motor–drive matching and component selection remain essential; tuning cannot compensate for incompatible or undersized equipment.

Verify the production cycle afterwards

Check the actual motion with and without the working load, in the directions the application uses. Review following error, overshoot, settling time, noise and torque/current traces. An axis reaching its torque limit may need more than a gain adjustment. If abrupt acceleration excites the mechanism, consider an S-curve motion profile as a separate motion-planning setting.

Changes to a gearbox, coupling, belt tension or payload can justify checking the existing settings again. Where necessary, repeat the manufacturer’s procedure and inspect control gains against measured behaviour. Parameters from another machine are a poor substitute for evidence from the axis being commissioned.

Editor’s note

The real acceptance test is the machine’s working cycle. Binding, backlash, loose connections, insufficient torque and faulty feedback should be addressed before expecting tuning to help. A successful completion message does not establish optimum performance at every load. Manual tuning can produce excellent results and may refine an automatic result; the two methods are complementary.

Continue exploring

Advanced control approaches in servo systems · Servo systems overview

Technical references

Kollmorgen — Servo System Tuning · Kollmorgen — Automatic Tuning · Kollmorgen — Advanced Servo Tuner · Kollmorgen — Quick Tune · Yaskawa — SigmaWin+ Tuning Training