6ES5 701-1LA11
6ES5 701-1LA11 Siemens SIMATIC S5-115U ER 701-1 Expansion Rack
The 6ES5 701-1LA11 is the ER 701-1 rack for centralized expansion unit EU 1 in the S5-115U SIMATIC S5 system. This S5 expansion rack has nine I/O positions, numbered 0–8, and a dedicated IM slot. An S5-115U processor such as the CPU 941 stays in the central controller.
Supported module positions
The slot plan covers compatible digital input, digital output and combined digital I/O modules. Compatible analog modules require an IM 306. Siemens Figure 3-10 excludes the 434-7 digital input family and ES 902-format S5-135U/155U modules. EU 1 also excludes modules that generate interrupts.
Connecting with IM 305 or IM 306
The 6ES5 305-7LA11 comes with a 0.5 m cable and the 6ES5 305-7LB11 with a 1.5 m cable. With an IM 305, the setup supports one EU 1 with fixed slot addressing and a 1 A supply limit for that unit. An IM 306 supports variable slot addressing and up to three EU 1 racks, with 2.5 m total cable length and a 2 A combined supply limit for the expansion units.
EU 1 draws power from the central controller’s power supply through the interface. The Siemens centralized layout includes central racks such as the CR 700-0 and CR 700-3. An IM 306 link uses 705-series cables. The 705-0AF00 is 0.5 m long and the 705-0BB20 is 1.25 m. Check the total run and the cable route inside the cabinet.
Check the full order number on the label before buying. Siemens lists the 701-1LA12 under a separate order number. The ER 701-2LA11 and ER 701-3LA13 serve different layouts. Match the rack label, fitted IM and cable to the installation.
Editor’s note
1. Record the layout before removal. Photograph the rack label, each board’s slot number and the full part number on the interface module.
2. If I/O drops out across the rack, trace the shared connection. Isolate the supply. Check the interface from the central controller to EU 1, cable seating at both ends and the connectors.
3. If only one position fails, inspect that position first. Check the front connector, board guide and backplane socket. Match the full module code to the original slot number.
4. Preserve the addressing. With IM 305, the slot order determines the address. With IM 306, photograph the address selector positions and compare them before commissioning the replacement.
5. Test analog I/O separately. If digital cards work and analog readings are missing, first confirm an IM 306 is fitted, then check the analog module’s address and front connector.
6. Ask for a specific used-rack test. Request the slot numbers tested with an I/O module, the IM part number used and close-up photos of the backplane sockets.
To offer a rack for sale, send the full part number, a backplane photo and test status to otomasyonavm@gmail.com.
PDF and slot layout
Siemens S5-115U system manual (English PDF). See Figure 3-10 for slot positions and Table 3-2 and Figure 3-19 for centralized wiring. S5-115 PDF archive.
Related topics
S5 Interface Modules · ER 701-2LA12 · 6ES5 460-7LA13 analog input · About Siemens S5 PLC
Navigation
S5 Racks · S5 Modules · SIMATIC S5 · Second-hand Siemens