Delta DVP40EC00T3
Delta DVP40EC00T3 | PLC with 24 inputs and 16 NPN transistor outputs
The Delta DVP40EC00T3 is a 100–240 V AC main unit in the DVP-EC3 series. It has 24 digital inputs rated at 24 V DC and 16 NPN open-collector transistor outputs. For packaging, conveyor and basic sequencing applications, the PLC reads the sensors, the CPU runs the sequence and the outputs switch the field loads.
Digital inputs and high-speed counting
The built-in PLC inputs and outputs use octal addresses X0–X27 and Y0–Y17. When connecting an inductive sensor, identify its PNP or NPN output and check the S/S common for the selected sink/source arrangement.
Delta’s electrical table lists 20 kHz for X0/X1, 10 kHz for X2–X17 and 60 Hz for X20–X27. For high-speed counting with an incremental encoder, check the applicable limit for the counting mode, input terminals and filter setting. A differential line-driver encoder needs an interface suited to the 24 V input.
Pulse outputs and panel wiring
Delta’s catalogue lists independent pulse outputs on Y0 and Y1 at up to 10 kHz for hardware V8.00 and later. Check the electrical interface and required pulse rate when selecting a servo drive. The drive powers the servo motor.
UP0/ZP0 serves Y0–Y7 and UP1/ZP1 serves Y10–Y17. Check load current and the external 24 V DC auxiliary supply for these groups in the manual. Use suitable suppression for coils or interface relays. Check the DIN rail layout and protective grounding during installation. If the project requires analog inputs or local expansion, consider an expandable CPU such as the DVP40ES200T.
Programming software and cables
Use WPLSoft to read and back up the existing ladder program. Earlier EC3 units are in the 4K class. Delta’s programming manual identifies the updated variant with firmware V8.60 and later as EC3-8K. In ISPSoft, select the matching CPU target and configure the serial connection in COMMGR. Verify the firmware and instruction support before writing the program to the PLC.
For COM1 (RS-232), use UC-PRG020-12A with a USB-equipped PC or UC-MS020-01A with a native serial port. Install the USB cable driver and select the COM port assigned by Windows. For Modbus over COM2 (RS-485), match the station address, baud rate and serial frame settings. Delta PLC cable options
Related Delta models
The DVP40EC00R3 has the same I/O count with relay outputs. The DVP32EC00T3 offers 16 inputs and 16 transistor outputs. The DVP48EC00T3 offers 28 inputs and 20 transistor outputs, and the DVP60EC00T3 offers 36 inputs and 24 transistor outputs. Compare the terminals, load wiring and program when changing models.
Editor’s note
When buying used, ask for a close-up of the nameplate and the CPU version read online.
Back up the program and Modbus settings before removal. Match the nameplate code to the project target.
If an output LED lights but the load stays off, check the auxiliary supply for that UP/ZP group and the load return.
If encoder counts drift, check the selected X terminal and input filter first.
For pulse positioning, confirm the drive’s command format first. Make the initial move at low speed under safe test conditions.
PDFs and internal references
Delta DVP PLC files · DVP-EC3 hardware and terminal sheet (PDF) · Delta DVP-EC3 · Delta DVP PLC series
External references
Delta DVP catalogue · Delta cable selection guide, section 1.3 · Delta DVP-PLC programming manual