Delta DVP12SC11R

Delta DVP12SC11R – DVP-SC PLC with 8 Inputs and 4 Relay Outputs

Delta DVP12SC11R is a legacy Delta DVP-SC PLC CPU. The model table in Delta’s 2007 Russian-language DVP catalogue shows a 24 V DC supply, eight digital inputs and four relay outputs. The same table lists the DVP12SC11T with four transistor outputs.

Relay outputs and application selection

With a suitable load and contact rating, relay outputs can handle sequence control, signalling or the control circuit of a contactor. A separate manufacturer wiring sheet, contact current rating and common-terminal layout could not be verified for the R variant. When replacing the unit, check the load voltage, inrush current and common-terminal arrangement against the markings on the hardware.

The 100 kHz heading on the 2007 catalogue page applies to the SC series. Delta’s detailed pulse-output and terminal diagrams are labelled DVP12SC11T. If position control requires pulse commands to a servo drive, consult the transistor-output T model’s documentation. For an R installation with an encoder or high-speed counter, verify the input type, addresses and speed limit on the actual hardware.

Programming software and cable

Start with WPLSoft for a legacy DVP-SC project and check the CPU type when connecting online. Read the original ladder program from the PLC and save a backup before editing. Delta’s legacy ISPSoft compatibility table specifies CPU firmware V1.4 or later for the DVP-SC series. Confirm the R unit’s connection with your software version and actual CPU.

Delta’s SC instruction sheet lists DVPACAB215, DVPACAB230 and DVPACAB2A30 for PC connection over RS-232. Check the port type and pinout on the R unit before connecting one of these cables. For a PC without a serial port, install the driver for a compatible USB-to-RS-232 adapter and select its COM port.

Expansion and cabinet replacement

Check CPU support, module revision and supply capacity when selecting DVP Slim digital modules, analog modules or temperature modules. Record the order and part numbers of the existing expansion modules. When changing CPUs, compare the instructions, addresses and PLC communication settings as well as the number of inputs and outputs.

Editor’s Note

Ask for a clear photo of the side label and terminal markings when buying second-hand. Check the full DVP12SC11R code.

Before removing the old unit, back up its program and communication settings. Photograph the module order and wire labels.

When a relay LED lights, confirm that a suitable low-voltage test load responds. Check the outputs one at a time.

Before testing the inputs, check the PNP or NPN sensor type and common connection. Use the terminal markings to identify each connection.

If inputs or readings fluctuate when a contactor energises, inspect cable routing, grounding and sources of electromagnetic interference.

Related topics and PLCs

DVP12SC11T SC transistor-output model · DVP12SA11R SA relay-output model · DVP14SS11R2 SS relay-output model · DVP12SE11R SE relay-output model

Delta DVP PLC series · Second-hand Delta models · Delta DVP PLC PDF files

External references

Delta DVP catalogue, R and T model table (2007, RU) · Delta DVP12SC11T instruction sheet (2006, EN, T model) · Delta note on SC pulse outputs and programming cable · Delta legacy ISPSoft firmware compatibility table