Battery Directive 2006/66/EC

From the former directive to current EU battery rules
Directive 2006/66/EC, adopted on 6 September 2006, regulated certain substances in batteries and accumulators, separate collection of their waste and recycling in the European Union. It should no longer be presented as the complete current framework: it was repealed from 18 August 2025, subject to specific transitional provisions. The main framework is now Regulation (EU) 2023/1542 concerning batteries and waste batteries. This distinction matters when assessing older documentation and battery and accumulator standards.
Legislation checked: 18 October 2026. The consolidated regulation dated 13 August 2026 was used.
Which products did the directive cover?
The former framework generally covered portable, automotive and industrial batteries and accumulators, with specific defence and space-related exclusions. Terms such as alkaline, NiMH, NiCd and lithium-ion describe chemistry; the legal battery category follows the relevant definitions and intended use. Small batteries do not automatically all belong to the same category, and rechargeable products do not all carry identical obligations.
Mercury, cadmium and lead were treated differently
The directive's main substance restrictions concerned mercury and cadmium in portable batteries, with exemptions amended over time. It is incorrect to describe the directive as imposing a general lead ban across every battery type. For example, lead-acid batteries were not wholly prohibited under the directive simply because they contained lead.
A marking threshold is different from a substance restriction
Article 21 of the former directive required the Pb symbol for batteries containing more than 0.004% lead by weight. This was a labelling threshold, not a direct lead ban. The current regulation also treats substance restrictions and chemical-symbol requirements in separate provisions. An assessment today must consider battery category, applicable exemptions and the current restriction conditions in Annex I.
Separate collection and recycling are different stages
The directive sought to keep waste batteries out of mixed municipal waste and route them through suitable collection systems. Free collection of waste portable batteries, without an obligation to purchase a replacement, was a central principle. End-of-life management for battery packs likewise involves more than storing products in a container: suitable treatment and recycling routes are needed. Collection rates, recycling efficiency and material recovery rates measure different outcomes and their percentages are not interchangeable.
Producer responsibility and business roles
Extended producer responsibility (EPR) provides for financing waste-battery collection and treatment through the relevant producer responsibility system. The legal term “producer” does not always mean only the physical factory; first supply to a market, branding, imports and distance sales can affect the role. Under the current framework, registration, financing, collection arrangements and reporting must be assessed alongside implementation in the relevant Member State. EPR and supply-chain due diligence are separate obligations.
Why is the new regulation broader?
Regulation (EU) 2023/1542 distinguishes portable, light means of transport (LMT), electric vehicle, industrial, and starting, lighting and ignition (SLI) batteries. Electric vehicle batteries should not be assumed to face the same requirements as small consumer batteries. Alongside waste management, the new framework introduces category-specific provisions on sustainability, performance, safety, conformity assessment, marking and traceability. A directive is transposed into national law, whereas an EU regulation applies directly in Member States; administrative arrangements and penalties may still require national measures.
Transitional provisions and application dates
18 August 2025 was the general repeal date for the former directive and the application date for Chapter VIII of the new regulation on waste-battery management. However, Article 11 of the former directive continues until 18 February 2027. The transitional provision on transmitting data to the Commission under Article 12(4) and (5) also continues until 30 June 2027. It is therefore inaccurate to say every old provision ended on the same day.
Labels, QR codes and battery passports
For certain labelling obligations under Article 13(1)–(3), the relevant date is the later of 18 August 2026 and 18 months after the relevant implementing act enters into force. One calendar date should not be presented as the start of every labelling requirement.
From 18 February 2027, QR-code marking is prescribed for all batteries. The digital battery passport, however, does not apply identically to every cell: it covers LMT batteries, industrial batteries above 2 kWh and electric vehicle batteries. A QR code and a battery passport are different concepts. Article 11 of the new regulation, addressing removability and replaceability, also applies from that date, subject to its relevant derogations.
When do supply-chain due diligence obligations apply?
The application date for the relevant battery due diligence obligations was postponed by the 2025 amendment to 18 August 2027. These provisions address specified social and environmental risks in raw-material sourcing, with scope and turnover exemptions. This postponement does not defer EPR or every product-compliance requirement until 2027.
Safety standards and technical documentation
For example, IEC 62133 addresses safety for specified portable rechargeable cells and batteries, while IEC 62660 concerns relevant testing and performance subjects for lithium-ion cells used in electric vehicle propulsion. Reports against these standards do not replace waste-management, substance-restriction or producer-registration obligations. Similarly, documentation referring only to the former directive is not a complete current technical file.
What should purchasing and system design check?
Identify the product's chemistry, legal category, intended use and target market together. Manufacturer and importer information, the applicable declaration of conformity, required markings, technical reports and end-of-life collection arrangements should be consistent. A compatible battery charger or battery accessory does not automatically establish the battery's compliance with all legislation. Use in Türkiye and placement on the EU market have different scopes; this explanation of EU legislation does not describe every obligation applicable in Türkiye.
Related battery topics
For background, see what a battery is, lithium battery types and battery varieties. For the distinction between technical standards, explore IEC 60086 and IEC 61951.
Supporting topics from other categories
For equipment-level assessment, examine the scope of RoHS and WEEE; for applications, UPS systems and electric vehicle charging standards; and for supply equipment, power supply standards. Requirements under these subjects do not replace battery legislation.
Batteries and battery chargers main page. Power supplies main page.