6ES5 710-8MA21
Siemens main menu › SIMATIC S7 family › ET 200 › Mounting accessories
6ES5 710-8MA21 — Siemens SIMATIC 530 mm Mounting Rail
6ES5 710-8MA21 is a Siemens SIMATIC standard 35 mm mounting rail, 530 mm long, specified for 600 mm cabinets. The 6ES5 order-number prefix does not restrict it to S5 systems; it is also recommended in the ET 200S installation documentation within the Siemens ET 200 family.
Technical description and application
Order number: 6ES5710-8MA21. Rail profile: 35 mm. Length: 530 mm. Material: Tin-plated steel strip. The 600 mm figure refers to the cabinet width; the rail itself is 530 mm long.
In an ET 200S installation, terminal modules and bases mount on the rail. Electrical connection components are separate parts. This product is a mechanical support, not an electronic backplane, signal module or power distribution bus.
Distinguishing the length options
The rail family includes 6ES5710-8MA11: 483 mm, 6ES5710-8MA21: 530 mm, 6ES5710-8MA31: 830 mm and 6ES5710-8MA41: 2000 mm. Check the complete order number when selecting ET 200 mounting accessories.
Five checks before selection and installation
1. Usable installation space: Do not rely on the cabinet’s external width alone. Measure the mounting plate, cable ducts, end restraints and maintenance clearances together.
2. Total station width: In the ET 200 station layout, allow for the interface, power modules, terminal bases and terminating module. Use the actual widths of the digital input modules, digital output modules and analog input modules.
3. Device mounting requirements: For the power supply modules and interface and communication modules, check the system’s required rail profile, orientation and clearances. Do not assume interchangeability with dedicated S7-300 profile rails.
4. Vibration and lateral movement: For increased vibration and shock, the Siemens ET 200S manual recommends fixing the rail at approximately 200 mm intervals and providing mechanical restraints at both ends of the station. This recommendation applies to the stated installation conditions.
5. Surface condition and grounding: Check for bending, damaged retaining edges and the electrical contact required by the installation design. Do not assume reliable contact through paint or corrosion; follow the system manual’s grounding arrangement.
Editor’s note
Measure a used rail rather than relying only on its label: the original order number specifies 530 mm, but the rail may have been cut. A bent profile or damaged retaining edge can also prevent modules from locking correctly. Confirm the actual length and condition before ordering.
PDF documentation and installation manuals
Use the Siemens ET 200 PDF and user manual page and consult Section 4.1, Basic principles of installation, in the ET 200S Operating Instructions. Rail options and fixing guidance appear on page 52 of the English A5E00515771-06 edition. For a different SIMATIC device, also check its own installation manual.
Related topics
Terminal bases • Connection modules • Digital inputs • Digital outputs • Power distribution • Additional modules
Otomasyon AVM • Siemens guide
Siemens main menu | SIMATIC S7 family | ET 200 module categories | ET 200 PDF archive