6ES7321-1FH00-0AA0

Siemens 6ES7321-1FH00-0AA0 S7-300 SM 321 Digital Input Module

Siemens 6ES7321-1FH00-0AA0 is an SM 321 module with 16 digital inputs for SIMATIC S7-300 systems. It detects nominal 120/230 V AC field signals and transfers their status to the PLC program. The inputs are electrically isolated in groups of four. It belongs to the S7-300 digital input module range for applications requiring AC control and status signals.

Input characteristics and signal detection

The rated input frequency range is 47–63 Hz. The manufacturer specifies 0–40 V AC for signal “0” and 79–264 V AC for signal “1”. A definite logic state should not be assumed for voltages between these ranges. At the rated input voltage, the specified input delay is 25 ms for both rising and falling transitions.

A green LED for each channel indicates its input status. The module provides no hardware interrupts or diagnostic functions. An LED indication alone therefore does not confirm the condition of the complete field circuit. When monitoring short pulses, assess the input delay together with the CPU scan time.

Field devices and front connector

Field wiring uses a 20-pin front connector. Confirm separately whether the connector is included with the offered unit. Compare channel and neutral connections with the module wiring diagram and the existing cabinet drawings. Recording wire labels before removal helps preserve the correct input assignments during replacement.

The module can be used with suitably rated pushbuttons and limit switches. The manufacturer also supports compatible two-wire or three-wire AC proximity switches; the maximum permissible off-state current for a two-wire sensor is 2 mA. When selecting inductive sensors or photoelectric sensors, verify AC output compatibility and off-state current.

Editor’s note: isolation and phase connections

Isolation in groups of four does not permit the groups to be supplied from different phases. Siemens requires all field supply voltages for this module to use the same phase. Group isolation and phase selection must be assessed separately. De-energize the relevant circuits before wiring or replacing the module; qualified personnel should follow the manufacturer’s connection diagram.

CPU and station compatibility

Check the installed S7-300 CPU, module slot, input start address and programmed channel assignments. For ET 200M applications, include the interface module and station configuration in the assessment. When comparing SM 321 modules, review the complete order number, input voltage, channel count and wiring arrangement together.

Evaluating a used module

Inspect the nameplate, hardware revision, front connector socket, cover and rear bus connections. Check for corrosion, heat damage, broken latches and signs of previous repair. Functional assessment should test all 16 inputs individually using a suitable protected test setup and compare the LED indications with the input states read by the PLC.

Provide the complete product code, required quantity and a photograph of the installed module’s nameplate when requesting a quotation. Confirm the included front connector and other accessories, physical condition and any available test record for the actual offered unit.

PDF files and technical documentation

Visit the S7-300 PDF files section for related documentation. The manufacturer’s wiring diagram and technical specifications appear in section 3.16, printed pages 99–101, of the Siemens S7-300 Module Data manual.

Related topics and product groups

Siemens S7-300 | Digital input modules | Digital output modules | Analog modules

CPU modules | Siemens S7 PLC | PLCs and modules | ET 200 systems

Used PLC power supplies | Sensors | Sensor connectors | S7-300 PDF files

Used Siemens equipment | Used automation equipment | 6ES7321-1EH00-0AA0 | 6ES7321-1FF01-0AA0