6ES7 142-0BF01-0XB0

Siemens 6ES7142-0BF01-0XB0 ET 200C 8-Channel Digital Output Module

6ES7142-0BF01-0XB0 is an 8-channel, 24 V DC / 0.5 A digital output field module in the SIMATIC ET 200C family. Part of the Siemens industrial automation range, it controls suitable DC valves, relays and signaling loads. When selecting actuators, remember that the 0.5 A rating applies to each channel.

Within the Siemens ET 200 distributed I/O family, ET 200C supports field connections directly on the machine. For industrial automation applications, the existing cable and connector arrangement matters alongside the control project. Record the loads connected to each socket and their cable labels as well as the module order number before replacement.

Selecting loads for a 0.5 A output

In PLC-based control applications, assess coil voltage, continuous current and energization behavior together. A 24 V operating voltage alone does not establish load compatibility. Check the initial current demand of lamps and electronic loads, and the specified suppression circuit for coils. Reassess the circuit whenever the connected load changes.

Five checks before selection or replacement

1. Complete model and hardware revision: Read the full 6ES7142-0BF01-0XB0 order number and any E-Stand marking on the label. When reviewing ET 200 system architecture and module selection, do not assume equal output ratings from similar housings or order numbers. Confirm that the wiring drawings and project records match the installed device.

2. PROFIBUS DP connection: ET 200C uses PROFIBUS DP field communication. In SIMATIC S7 control systems, compare the station address, selected device definition and output addresses with the existing project. Before replacing components in the Siemens PLC and I/O range, back up the working project and check the bus cable, shield connection and line termination.

3. Electronics and load power: Continuing communication does not by itself confirm that power reaches the actuator. Measure supply voltage at the module and load while the output is operating, rather than only at the power supply. If several outputs are affected together, examine their common supply and return path; for a single-channel problem, focus on that load's cable and connections.

4. Separate commands from physical output: An “on” indication on HMI operator panels often represents only a software command. Compare the PLC output bit, RUN, BF, DIA and UL indicators and actual actuator response. Record the affected channel, command state and measured voltage; “no output” alone does not locate the fault.

5. Connectors and field conditions: Inspect sockets for loose contacts, corrosion, damaged seals and signs of water at cable entries. Close unused connections with suitable caps. When making a replacement cable, verify pin assignments against connection information for the exact device revision; do not transfer a socket diagram from another ET 200 family.

PDF manuals and revision checks

Use the Siemens ET 200 PDF manuals page for documentation resources. Section 11.2 covers the 0BF00 version in the ET 200C Distributed I/O Station manual, EWA 4NEB 812 6119-02b. Use it to understand the system architecture, and verify pin assignments and parameters for 0BF01 separately. Share the label photograph and existing connection details through Siemens product technical enquiries.

Editor's note: A load consuming 18 W continuously at 24 V DC draws approximately 0.75 A, exceeding the 0.5 A channel limit. Matching voltage alone is insufficient. When replacing a coil or relay, check the new component's current demand; matching mechanical dimensions do not imply the same electrical load.

Related topics and Siemens navigation

Product families
Siemens main menu  |  Siemens PLC products  |  SIMATIC S7

ET 200 resources
ET 200 products  |  ET 200 system overview  |  ET 200 PDF manuals

Control and assistance
HMI operator panels  |  SCADA systems  |  Siemens product enquiries