6ES7 138-4FA01-0AB0
6ES7 138-4FA01-0AB0 — Siemens ET 200S 4/8 F-DI PROFIsafe Input Module
6ES7 138-4FA01-0AB0 is a 24 V DC fail-safe digital input module for SIMATIC ET 200S stations. Part of the Siemens industrial automation range, it is designated 4/8 F-DI PROFIsafe. It acquires safety-related signals, such as emergency-stop and guard-door contacts, for transmission to the safety controller through the ET 200 distributed I/O system.
What does 4/8 inputs mean?
The module has eight physical digital inputs. Single-channel evaluation supports eight signals; dual-channel evaluation pairs the inputs to monitor four process signals. The “4/8” designation therefore does not mean four inputs and eight outputs. This is an F-DI input module, not an F-DO module for switching loads.
Siemens lists eight-input operation for applications up to SIL 2 and four-signal safety evaluation for applications up to SIL 3. These capabilities depend on suitable sensors, wiring and configuration. When planning the ET 200 system architecture, determine the required signal count together with the target safety level.
Five points to check before selection
1. Sensor contact arrangement: Single-channel, dual-channel equivalent and dual-channel nonequivalent wiring require different evaluation settings. Two NC contacts, for example, differ from an NO/NC contact pair. In industrial automation applications, “24 V sensor” alone is not enough to establish suitability; contact arrangement and safety capability also matter.
2. Input evaluation and timing: The 1oo1 / 1oo2 setting must match the wiring. Assess the switching delay between two sensor contacts together with discrepancy time and the configured response to discrepancy. Within the PLC control architecture, these settings should not be changed merely to suppress a fault.
3. Sensor supply: In Siemens' example for this model, cyclic short-circuit testing requires the internal sensor supplies and deactivation of unused channels. Wiring and test settings for externally powered sensors require separate verification.
4. Terminal module: A Siemens application containing this model uses the TM-E30C46-A1, 6ES7 193-4CF50-0AA0 terminal module. This is a documented pairing, not an exhaustive list of terminal options. Check the base's code, wiring arrangement and delivery scope as well as the electronic module.
5. Existing project and version: In SIMATIC S7 safety control systems, assess the F-CPU, station interface, PROFIsafe address and hardware-catalog selection together. If replacing 4FA01 with 4FA02, 4FA03 or 4FA04, consult the manufacturer's replacement conditions; similar appearance alone is insufficient.
Where should troubleshooting begin?
For a fault on a dual-channel input, inspect both sensor contacts, terminal connections and project settings together. Alarm descriptions on HMI operator panels that identify the sensor and channel pair help maintenance staff locate the correct circuit. SCADA event records can help establish whether the fault occurs during guard movement, stopping or restarting.
Use the ET 200S safety documentation available through the Siemens ET 200 PDF manuals page for wiring and configuration details. Check that the document covers the 6ES7 138-4FA01-0AB0 version.
Editor's note: Input count alone is not enough to select this module. Sensor design, channel pairing and the safety program must follow the same validated design. Seeing a contact change state on a screen does not, by itself, prove that the safety function operates correctly. Validate the complete function after replacement.
For replacement assessment, provide the complete model, quantity, label photograph, terminal code and any fault message through our Siemens product selection and technical contact page.
Related topics and Siemens navigation
Product families
Siemens main menu |
Siemens PLC products |
SIMATIC S7
ET 200 resources
ET 200 products |
ET 200 system information |
ET 200 PDF manuals
Control and support
HMI operator panels |
SCADA systems |
Contact for Siemens products