6ES7321-1CH20-0AA0

Siemens 6ES7321-1CH20-0AA0 SM321 Digital Input Module

Siemens 6ES7321-1CH20-0AA0 is an SM321 module for the SIMATIC S7-300 family, featuring 16 digital inputs rated for 48–125 V DC. It transfers compatible field status signals to the PLC program. The inputs form two groups of eight, with field wiring connected through a 20-pin front connector.

Input levels and signal delay

The logic “1” input range is 30–146 V DC, while the logic “0” range is −146 to +15 V DC. These thresholds should be distinguished from the nominal 48–125 V DC rating. Typical input current at logic “1” is 3.5 mA. Input delay is 0.1–3.5 ms for a rising transition and 0.7–3.0 ms for a falling transition; it is not configurable. Overall application response also depends on the S7-300 CPU cycle and how the program processes the signal.

Group isolation and temperature limits

Isolation is provided between the inputs and backplane bus, and between groups of eight; individual channels are not independently isolated. The Siemens manual specifies simultaneous active-input limits per group. Each group permits eight active inputs with horizontal mounting up to 50 °C or vertical mounting up to 40 °C. With horizontal mounting above 50 °C and up to 60 °C, input voltages above 60 V reduce the limit to six active inputs per group; eight remain permissible at input voltages up to 60 V.

Wiring and system compatibility

Check the full order number, field voltage, group common connections and 20-pin connector assignment together. Verify the hardware configuration and input addresses in the existing Siemens PLC project. For two-wire sensors, confirm voltage compatibility and observe the maximum permissible quiescent current of 1 mA. Sensor off-state leakage and on-state voltage drop both matter for reliable input detection.

Status indicators and used-module inspection

Each input has a green status LED. This model provides neither hardware interrupts nor diagnostic alarms and has no red SF group-error indicator. Troubleshooting should combine LED observations, terminal measurements and the input state reported by the PLC.

When assessing a used Siemens module, inspect its label, housing, backplane connections and front connector. Qualified personnel should verify switching on all 16 channels individually using a suitable DC test setup, respecting temperature and group limits, and compare the LEDs with the PLC input states. Confirm whether the front connector is included in the delivery.

For a quotation, provide order number 6ES7321-1CH20-0AA0, the required quantity, a photograph of the existing module label and any front-connector requirement. Product condition, test coverage and delivery contents should be confirmed for the specific unit offered.

Technical documentation

Refer to the Siemens product data sheet for electrical ratings and section 3.15 of the S7-300 Module Data manual for wiring and group-loading information. Further documents are available on the S7-300 files page.

Related topics and product groups

S7-300 modules · S7-300 CPU modules · S7-300 digital output modules · S7-300 PDFs and manuals

Siemens PLC products · Used Siemens products · Used automation products · OtomasyonAVM