6ES5 101-8UA12

Siemens 6ES5 101-8UA12 — SIMATIC S5-101U Relay Central Controller

The Siemens 6ES5 101-8UA12 is a compact S5-101U central controller in the SIMATIC S5 range. It runs the control program and provides 20 digital inputs and 12 relay contact outputs. These digital I/O points are wired directly to the unit’s terminals. The STEP 5 program capacity is 1K statements.

Power supply, inputs and relay outputs

The controller uses a 220/240 V AC mains supply. Its digital inputs accept 24 V DC signals. The front panel marks the input addresses as I 0.0–I 2.3 and the output addresses as Q 0.0–Q 1.3. When adding an external DC power supply or an inductive proximity sensor, verify the field voltage and common reference against the cabinet drawing.

The relay contacts switch the load circuit. Check the load voltage, current and common terminals against the connection information for the actual unit. Trace the mains supply, 24 V input signals and relay load circuit separately on the cabinet drawing before wiring.

STEP 5, memory and expansion

Connect the programmer through the front PG port. The S5-101U family manual lists the 6ES5 375-0LA15 EPROM among the memory submodules. Exact-model records list the 8UA12 as originally supplied without a backup battery. Check the battery and memory fitted to a used unit. Back up the existing program before changing the memory submodule.

Siemens lists the PG 605U, the PG 615 and the 6ES5 731-1BD20 programming cable for the PG 670/675 in the family accessory table. If the cabinet uses SINEC L1, trace the communications connection at the central controller’s TTY interface.

A short ribbon cable connects the expansion unit to the central controller’s EG expansion interface. Identify the PG and EG connectors separately when checking the S5 cables. The 8UC11 is a relay expansion unit. The 8UC31 is a 24 V DC expansion unit with transistor outputs. Record the full code, supply and output type of the fitted expansion unit.

Related central controllers and used-unit checks

The 8UA13 is also a central controller with 20 inputs and 12 relay outputs. The 8UB13 has 10 inputs and 6 relay outputs. The 8UA23 has triac outputs and the 8UA33 has transistor outputs. Match the full order number, supply, output technology and terminal layout when choosing a replacement.

Ask for photographs of the nameplate, PG and EG connectors, battery compartment and relay terminals. Confirm that the unit switches between RUN and STOP, that STEP 5 can read the inputs, and that the relay outputs can switch a suitable test load.

Editor’s Note
If an output LED lights but its load stays off, have the relay contact and the field circuit checked separately. Ask the bench tester to record the Q address, test load and number of switching cycles.

PDF archive

See Siemens family manual pages 2-3 for the expansion connection and 4-4 for the PG and EG interfaces. The full-complement relay wiring diagram in that manual is marked 8UA13. The ADEGIS list below gives the basic ratings for the exact 8UA12 order number. Shared Siemens SIMATIC S5 PDF archive

Related topics

About Siemens S5 PLCs · S5 digital I/O modules

Navigation · S5 central and expansion units · Siemens SIMATIC S5 PLC · Used Siemens automation equipment

References

Siemens SIMATIC S5-101U Operating Instructions, 6ES5 998-0UC23 (English family manual)
ADEGIS SIMATIC S5 component list, exact 8UA12 entry, p. 2 (English product entry)
Amikon 6ES5 101-8UA12 product record and unit photographs