6ES5 101-8UA11

Siemens 6ES5 101-8UA11 | SIMATIC S5-101U Relay Central Controller

The 6ES5 101-8UA11 is an S5-101U central controller (CC) in the Siemens SIMATIC S5 range. It runs on 220 or 240 V AC mains power and has 20 × 24 V DC digital inputs and 12 relay outputs.

Inputs, outputs and power supply

The front panel shows input addresses I0.0–I2.3 and output addresses Q0.0–Q1.3. German notation uses E for inputs and A for outputs. The 24 V DC inputs can read signals from inductive sensors and control pushbuttons. The mains input and 24 V DC sensor supply terminals are marked separately on the panel.

When commissioning the relay contacts, check the voltage and current of loads such as contactor coils against the unit’s ratings. Verify the terminal and common connections against the existing panel wiring diagram.

STEP 5, memory and programmer connection

The central controller runs the STEP 5 program and has capacity for 1K (1,024 instructions). According to the S5-101U manual, a backup battery retains the contents of internal RAM. An EPROM or EEPROM memory module can store the program. The backup battery is a separate item for this order number.

The Siemens manual lists the PG 605U handheld programmer and the 6ES5 731-1BD20 cable for connecting a PG 670/675. Match the S5 cable to the programmer model and the controller’s PU/PG port.

Expansion and related versions

The 6ES5 101-8UC11 is an S5-101U expansion unit (EU) with 20 inputs at 24 V DC and 12 relay outputs. Siemens shows a short ribbon cable between the central controller and the expansion unit. Check the nameplate for the CC or EU designation when choosing a replacement.

The 6ES5 101-8UA12 and 6ES5 101-8UA13 are relay central controllers with the same I/O counts. The 6ES5 101-8UB13 has 10 inputs and 6 relay outputs. The 6ES5 101-8UA23 is the triac version, and the 6ES5 101-8UA33 is the transistor version. Match the full order number and hardware revision to the existing panel drawings before replacing the unit.

Checks for a used unit

Ask for a photo of the order number and hardware revision, a PU/PG connection test and test results for all 20 inputs and 12 relay outputs. For PLC diagnostics, the 5 V indicator shows internal power, while the RUN and STOP indicators show operating status. Check the relay contacts separately with a suitable test load.

Editor’s Note
Check the STEP 5 backup and the contents of the installed memory module before powering up. Siemens explains that the module contents are copied to internal RAM at power-up or on switching to RUN, overwriting the program already in RAM.

Manuals and PDF files

Section 3.4 of the Siemens S5-101U manual describes memory operation. The terminal drawing in Figure 10 covers the 8UA13. For the 8UA11, use the unit’s own terminal markings and the panel wiring diagram. OtomasyonAVM SIMATIC S5 PDF archive

Related topics

About Siemens S5 PLCs · S5 digital I/O modules · 6ES5 101-8UC31 expansion unit

Navigation

S5 CPU and unit directory · SIMATIC S5 range · Used Siemens automation · Used automation equipment

References

Siemens SIMATIC S5-101U family manual, EWA 4NEB 810 2119-02c (English PDF)
Allmendinger 6ES5 101-8UA11 technical part listing
Automation Wallinger 6ES5 101-8UA11 front panel photo