6ES5 255-3AA11

Siemens 6ES5 255-3AA11 IP 255 MONA-S5 Color Monitor Interface

The 6ES5 255-3AA11 is an IP 255 color monitor interface for SIMATIC S5. Exact-part records identify it as MONA-S5 or Mona A. This S5 special module acts as a display interface for an existing S5-135/155 process visualization system.

RGB wiring and display selection

The published front-panel photograph for this model shows three BNC connectors marked R, G and B and a Sub-D connector. Record the color and end labels on the video cables before disconnecting them. Verify the Sub-D pin functions on the machine wiring diagram.

The Scanmagnetics converter manual lists 24.3 kHz horizontal and 54.4 Hz vertical for its MONA S5 Mode 3 profile. Use this as a converter reference when selecting an industrial display or Siemens panel. Check the monitor’s own documentation for the required signal, sync format and scan range.

Rack and spare module matching

Record the S5 rack identification and existing slot. The S5-135U central controller, CPU 928 and CPU 946 pages help identify equipment in the system. Match the S5 PLC project, full card order number and monitor model when selecting a replacement.

The 3AA11 and MONA-C 3AC11 have separate order numbers. The converter manual also lists separate modes for MONA S5 and MONA-C. The AS 256 3AA11, AS 256 3AB11, CP 526 and CP 581 belong to different hardware families. Match the front connectors, card code and monitor profile together.

If the display starts but the values freeze, check S5 communications and the project data mapping. If the display stays dark, check monitor power and the video path separately. If the rack has lost power, verify the 955 power supply order number against the rack. For a retrofit with a used operator panel or SCADA, document the existing alarms and operator screens.

Editor’s note

Document the installation before removing the module. Follow the plant isolation procedure. Photograph the full part number, rack slot and R/G/B cable labels.

Start at the monitor if the screen is blank. Verify power and input selection. Then try a known-good cable and a monitor that accepts the same video profile.

Trace the relevant channel if a color is missing. With power isolated, check that color’s BNC connectors, cable continuity and input label. Use a test image to check the three colors separately.

Check sync if the picture rolls or splits. Compare the original monitor’s input data with the converter mode. Verify both horizontal and vertical scan frequencies.

Check the PLC if the image is present but values stop updating. Verify the CPU status and check whether the process value changes in the project. Test picture output and data updates separately.

Ask to see a working display after startup when buying used. Request the 3AA11 label, the monitor or converter model and a video of the color process display starting up.

To offer an IP 255 for sale, send the full part number, a photo of the front connectors and any display test results to otomasyonavm@gmail.com.

PDF and product references

+ Scanmagnetics RGB converter manual (English PDF) · Appendix D, MONA S5 and MONA-C video modes.

+ RGB converter manual (German PDF) · Viscotech, Appendix D.

+ Siemens S5-135U/155U system manual (English PDF) · §3.6, general monitor connection and shielding.

+ 6ES5 255-3AA11 product record and front-panel photograph

+ Shared S5 PDF archive

Related topics

+ 6ES5 255-3AC11 MONA-C

+ CP 526 color monitor processor

+ About Siemens S5 PLC

Navigation

+ S5 Special Modules

+ SIMATIC S5

+ Second-hand Siemens