6ES5 242-1AA12
Siemens 6ES5 242-1AA12 SIMATIC S5 IP 242 compact counter module
The 6ES5 242-1AA12 is a compact IP 242 counter module for SIMATIC S5. It receives counting pulses from field devices and makes the count available to the PLC program.
The Siemens S5-115U manual’s IP 242 family entry lists 0.9 A from the internal 5 V supply, installation in an adapter casing and operation without a fan requirement. These are family-level specifications. Compare the existing S5 rack order number, power supply and CPU label against the machine documentation when selecting a spare.
Wiring and signal checks
Identify the source of the counting pulses first. If the machine uses an incremental encoder, identify its output type. If it uses an inductive sensor, check the sensor’s output label. Use the machine’s 1AA12 wiring diagram to verify the input level and pins in use. Check the technical data for the full order number to establish the total channel count and frequency limit.
After isolating power, document the existing cable and connector with the channel labels. Check the shield and grounding against the machine schematic. Before applying a test signal, record the verified input level and reference terminal.
STEP 5 and troubleshooting
In the STEP 5 project, identify the address from which the count is read and the data area where it is stored. During online troubleshooting, track the input pulse, the value read from the module and the result in the program separately. If the trigger reaches a PLC input and the target count drives a PLC output, trace both on the machine schematic. In an encoder-based installation, check the encoder coupling and program scaling if the count disagrees with physical travel.
1AA13 and other IP 242 variants
The Niemann service list identifies the 6ES5 242-1AA13 as the successor to the 1AA12. If considering a 1AA13 spare, match the connectors, supply requirements and program addresses to the existing machine. The IP 242A 1AA31, IP 242A 1AA32, IP 242B 1AA41 and IP 240 1AA21 have separate order numbers. Use the full code and verified wiring diagram to select the replacement.
Editor’s note
1. For a used module, ask for photos showing the 242-1AA12 label, hardware revision and front connectors. Ask for a test video showing both the number of pulses applied and the count change in STEP 5.
2. Back up the STEP 5 project before removal. After isolating the supplies, photograph the rack slot, any address switches and the connector order. Record the adapter casing as well.
3. If the count stays fixed, check the signal at the sensor output and then at the module input specified in the machine diagram. If pulses reach the card, trace the start and reset conditions in the program.
4. If counting is accurate at low speed and drops at production speed, measure pulse width and frequency at the module input. Repeat the same number of revolutions or parts at both speeds and compare the results.
5. When fitting a 1AA13, run the first test under controlled conditions. Apply a known number of pulses and compare the start count, final count and any target-count output with the old card’s records.
6. If the count increases correctly but the machine fails to stop at the target, trace the target comparison and its control output in STEP 5 before replacing the counter.
Related topics
Used Siemens equipment
To sell a 6ES5 242-1AA12, send the quantity, working condition, label photo and asking price to otomasyonavm@gmail.com.
+ OtomasyonAVM SIMATIC S5 PDF archive
External sources
+ Siemens S5-115U manual, IP 242 family installation table (EN)
+ TPCOVN parts list, 6ES5 242-1AA12 (EN)
+ Niemann service list, 1AA12 and 1AA13 successor entry (DE)