6ES7 195-0BC01-0XA0
Siemens 6ES7195-0BC01-0XA0 SPC2 PROFIBUS-DP Communication ASIC
6ES7195-0BC01-0XA0 identifies a lead-free SPC2 ASIC for PROFIBUS-DP communication. Within the Siemens industrial automation range, it is a component for integration into electronic circuit boards. The product description specifies a maximum communication rate of 1.5 Mbit/s, 244 bytes of data and a six-piece package for laboratory development.
Although listed among ET 200 and other network interface components, this product is an integrated circuit rather than a rail-mounted I/O module or a complete communication board. For board repair or device development in machine and process automation applications, assess the circuit diagram, chip marking and software together before selecting it.
What does SPC2 do on the board?
Siemens' ASIC family documentation explains that SPC2 implements part of the data-link layer's bus protocol processing in hardware. An external microprocessor handles the remaining interface and management functions. In PLC-based control systems, replacing the chip alone therefore does not establish software compatibility or restore every function of the communication board.
Five checks before selection or repair
1. Order number and chip marking: Check 6ES7195-0BC01-0XA0 against the package label, and compare the installed chip marking with the board's bill of materials. Similar order numbers among Siemens PLC and communication products can identify different components. The “six pieces” in the product description refers to package quantity, not channels or network stations.
2. Communication rate and data length: Compare the stated 1.5 Mbit/s limit with the network operating rate. Do not interpret 244 bytes as PLC program memory or a physical I/O count. For a device sharing a network with Siemens ET 200 distributed I/O systems, check its actual input/output lengths, device GSD file and master configuration together.
3. Processor and software compatibility: Identify the processor interface, initialization software and installed SPC2 revision. On a board communicating with SIMATIC S7 control systems, distinguish SPC2, SPC3 and ASPC2 carefully. Moving to another ASIC is a design change that requires separate verification of pin assignments and software compatibility.
4. Board-level electrical conditions: Verify supply voltage, clock and reset circuits, logic levels and orientation using documentation for the board and chip revision. An ET 200 system and module overview helps with station-level assessment, but does not replace an ASIC pinout. Apply ESD protection and suitable rework conditions during component removal and soldering.
5. Isolating the fault: Before deciding to replace the ASIC, check the PROFIBUS cable, termination, connector and board line-driver circuitry. Then inspect power, clock, reset and processor access. Compare HMI operator panel communication alarms with PLC diagnostic records; a bus fault alone does not establish that SPC2 has failed.
PDF resources and document selection
Use the Siemens ET 200 PDF manuals page to access station and network documentation. Work on SPC2 requires chip-specific technical documentation and the device's circuit diagram. The general ASIC discussion in Siemens' ASPC2 Hardware User Description explains SPC2's role; electrical specifications for ASPC2 must not be applied to SPC2. Share the board reference and chip photographs through Siemens product technical enquiries.
Editor's note: Keep the SPC2 order number, board order number and chip marking together in the maintenance record. Checking the cable and line-driver stage first can prevent unnecessary chip removal. A general ET 200 catalog is not a pin-connection guide for this component.
Related topics and Siemens navigation
Product families
Siemens main menu | Siemens PLC products | SIMATIC S7
ET 200 resources
ET 200 products | ET 200 system overview | ET 200 PDF manuals
Control and assistance
HMI operator panels | SCADA systems | Siemens product enquiries