6ES7 193-4FL10-0AA0
Siemens main menu › Siemens S7 family › ET 200 › Terminal blocks
6ES7 193-4FL10-0AA0 — Siemens ET 200S TE-U120S4x10 Screw-Type Add-on Terminal
6ES7 193-4FL10-0AA0 is a TE-U120S4x10 Siemens screw-type add-on terminal. It provides extra connection points for sensor and actuator wiring in ET 200S and ET 200S COMPACT systems. It has 40 terminal points and adds no electronic input or output channels.
Purpose
It helps distribute additional potentials when the existing ET 200S terminal bases do not provide enough supply or common-return connections. It can keep the field wiring arrangement close to the station. Follow the relevant module wiring diagram for sensors connected to digital input modules and actuators connected to digital output modules.
Five checks before selection
1. Screw or spring connection: 6ES7193-4FL10-0AA0 / TE-U120S4x10 uses screw terminals; 6ES7193-4FL00-0AA0 / TE-U120C4x10 uses spring terminals. Keep FL10 and FL00 distinct when ordering. Record the connection method when selecting ET 200 mounting accessories.
2. Mechanical arrangement: It mounts on a COMPACT TM-C base or under a suitable 120 mm section of TM-P/TM-E bases. The two outer bases must have the same height, with no taller base between them. Measure the clearance to the cable duct below and allow service access.
3. Three-wire or four-wire connection: Siemens describes three-wire connection for 32 COMPACT channels and specifies two add-on terminals for four-wire connection. This does not mean that the accessory contains 32 electronic I/O channels. Determine the quantity from the actual wiring plan.
4. Bridge arrangement: Four groups of ten terminals can be interconnected using removable bridges. With the three factory-fitted bridges installed, all terminal points share one potential. Match the bridge arrangement to the potential distribution and grouping plan. Check interconnections before applying separate supplies.
5. Current and installation space: The manual specifies a 10 A current-carrying capacity for the add-on terminal and its bridges. Do not interpret this as 10 A independently available at every terminal point. Assess the ET 200S power supply modules, conductors and protective devices against the combined load. Body dimensions are 120 × 38 × 30 mm, or 120 × 79 × 30 mm with the fixing bracket.
Editor’s note
Do not assume that a used add-on terminal retains its factory bridge arrangement. Bridges may have been removed or groups interconnected for the previous application. When reconfiguring an ET 200 station, isolate the supplies and check group continuity, screw terminals, retaining parts and signs of overheating.
PDF documentation and installation references
Use the Siemens ET 200 PDF and user manual page. Sections 4.5 and 4.6 of the ET 200S Operating Instructions explain add-on terminal installation and bridge arrangements. For dimensions and grouping, consult the TE-U120x4x10 section in Terminal Modules / Modules terminaux. The relevant information appears on pages 24–25 of the French A5E01120035-01 edition.
Related topics
Terminal bases • Connection modules • Digital inputs • Digital outputs • Power distribution • Additional modules
Otomasyon AVM • Siemens guide
Siemens main menu | SIMATIC S7 family | ET 200 module categories | ET 200 PDF archive