6ES5 184-3UA11

Siemens 6ES5 184-3UA11 | SIMATIC S5 EG 184U expansion rack

The 6ES5 184-3UA11 is an EG 184U expansion rack for adding I/O to a Siemens SIMATIC S5 central controller. Siemens uses EU 184U in its English manuals. This S5 rack has 21 physical slots, a cable duct and a fan assembly. The STEP 5 program runs on the CPU in the central controller.

Fan power and module power

The data sheet lists the fan assembly at 115/230 V AC. The system manual lists 120/230 V AC. Check the fan nameplate and voltage selector before energizing the rack. The 6ES5 184-3UA21 variant has a 24 V DC fan assembly.

The EU 183U and EU 185U expansion families have their own power supplies. In the EU 184U, the modules receive power through the interface link from the upstream S5 system power supply. The AC feed powers the fan assembly.

Interface link and slot assignment

In the documented S5-135U/155U configuration, central racks such as the 6ES5 188-3UA21 and 6ES5 188-3UA22 connect through an IM 300-5C at the source and an IM 312-5 in the expansion rack. The Siemens EU 184U slot chart assigns the IM 312-5 to position 163.

The manual also shows a local expansion connection using the IM 301-5CA12. Check the order numbers at both ends and the cable length when selecting interface modules and S5 connecting cables. Siemens specifies a 5 A limit per connection on the 6ES5 300-5CA11. Include all modules drawing current through that connection when checking the load.

Supported modules

The EU 184U slot chart lists positions for digital input, digital output and analog I/O cards. When recording the existing configuration, write down both the physical slot and the I/O address set on each card.

Selected non-paged IP cards in the special modules range have their own slot requirements. Install communications processors (CPs) in a rack with positions assigned to those processors.

When replacing a card such as the 6ES5 420-4UA13 input module or 6ES5 441-4UA12 output module, match the full order number, front connector, field supply and address setting.

Checking a used rack

Ask for photos of the rack and fan nameplates, the backplane connectors and the card guides. Confirm whether the interface module and cable come with the rack. A bench test should check the fan and verify that the CPU can access the fitted I/O cards.

Editor’s Note
If the fan is running and the expansion rack is unresponsive, check the IM 300-5C I/O fault LEDs, then the IM 312-5 connection and module power. These LEDs indicate that an I/O module has failed to respond to CPU access.

Manuals and PDF files

Section 4.2 of the S5-135U/155U system manual covers expansion racks. Section 7.1 covers the IM 300 and IM 312 links. OtomasyonAVM SIMATIC S5 PDF archive

Related topics

About Siemens S5 PLCs · S5 digital I/O cards · S5 expansion modules

Navigation

S5 CPU and rack directory · SIMATIC S5 range · Used Siemens automation · Used automation equipment

References

Siemens 6ES5184-3UA11 data sheet (EN, PDF)
Siemens S5-135U/155U System Manual, C79000-G8576-C199-07 (EN, PDF)
Siemens U Periphery, section C79000-B8576-C279-04 (EN, PDF)