6ES5 101-8UC11

Siemens 6ES5 101-8UC11 | SIMATIC S5-101U Relay Expansion Unit

The 6ES5 101-8UC11 is the S5-101U relay expansion unit (EU) in the Siemens SIMATIC S5 range. It adds 20 digital inputs at 24 V DC and 12 relay outputs to the central controller. The expansion unit runs on 220 or 240 V AC mains power.

Connection to the central controller

This S5 expansion unit mounts alongside the S5-101U central controller (CC) and connects through a short ribbon cable. Siemens lists 20 inputs and 12 relay outputs for the 6ES5 101-8UA13 central controller and 10 inputs and 6 relay outputs for the 6ES5 101-8UB13. The STEP 5 program running on the central controller addresses the expansion I/O.

Match S5 cables and connectors to their function. The short ribbon cable links the CC and EU. The 6ES5 731-1BD20 is a 3.2 m cable for connecting a PG670 or PG675 programmer to the central controller.

Inputs and sensor supply

The digital inputs use addresses I3.0–I5.3, shown as E3.0–E5.3 in the German manual. Optocouplers isolate the inputs from the internal supply. The inputs can read signals from inductive sensors and control pushbuttons in 24 V DC field circuits.

The built-in sensor supply delivers 24 V DC at up to 300 mA. If the cabinet uses an external 24 V DC power supply, check the existing field supply against the Siemens diagram.

Relay outputs and common terminals

The digital outputs use addresses Q2.0–Q3.3, shown as A2.0–A3.3 in the German manual. The 12 relay contacts form six pairs, with one common terminal per pair.

Siemens rates the contacts at 250 V AC / 1.5 A for AC-11 and 30 V DC / 0.5 A for DC-11. For loads such as contactor coils, check the coil voltage, current and switching frequency against the limits in the manual.

Related versions and checks for used units

The 6ES5 101-8UC21 expansion unit has 16 AC inputs and 8 triac outputs. The 6ES5 101-8UC31 has a 24 V DC supply, 20 inputs and 12 transistor outputs. The 6ES5 101-8UA23 and 6ES5 101-8UA33 are the triac and transistor central controller versions respectively.

When buying used S5 digital I/O hardware, check the full order number, the condition of the cable and connector, the 24 V sensor supply and the test results for all 12 relay contacts. If the work also involves the central controller, record the S5 memory module and check the STEP 5 program backup.

Editor’s Note
If the expansion unit loses power completely or its bus cable is disconnected, the central controller reads the expansion inputs as 1 in the program. To use the PLC diagnostics method described by Siemens, leave input I5.3 unwired and monitor that address in the program.

Manuals and PDF files

In the Siemens manual, Figure 14 shows the terminals and commons, section 3.5 covers fault behavior and section 5.3 gives the I/O ratings. OtomasyonAVM SIMATIC S5 PDF archive

Related topics

About Siemens S5 PLCs · 6ES5 101-8UA11 · 6ES5 101-8UA12

Navigation

S5 CPU and unit directory · SIMATIC S5 range · Used Siemens automation · Used automation equipment

References

Siemens S5-101U operating instructions, EWA 4NEB 810 2119-02c (English PDF)
Siemens S5-101U Betriebsanleitung, GWA 4NEB 810 2119-01b (German PDF)