invt DA200 servo fault codes 8

INVT DA200 Servo Fault Codes 8

This section covers INVT DA200 servo drive faults related to CANopen communication, PDO mapping, synchronization, CAN receive/transmit errors and excessive bus load.

For these faults, check the CANopen network state, baud rate, synchronization source, RPDO/TPDO configuration and PDO mapping together rather than repeatedly resetting the servo drive.

Er26-9 - PDO Mapping Not Allowed

Possible cause:
A parameter that is not permitted for PDO mapping may have been included in the PDO configuration.

Checks and solutions:
Check the access properties of the mapped objects. Make sure read-only PDO parameters are not mapped to an RPDO.

Er26-a - Synchronization Signal Too Fast

Possible cause:
The received communication frames may be arriving faster than the configured baud rate can support.

Checks and solutions:
Increase the data-frame transmission interval or synchronization-frame interval from the master station. If necessary, reconfigure the CANopen communication baud rate.

Er26-b - CAN Receive Error

Possible cause:
CAN communication may have gone offline, or the error count may have exceeded 128.

Checks and solutions:
Check the CANopen communication cables, connectors and network connections. If the wiring is normal, restart the servo drive.

Er26-c - CAN Transmit Error

Possible cause:
CAN communication may have gone offline, or the error count may have exceeded 128.

Checks and solutions:
Inspect the CANopen communication cables and network connections. Restart the servo drive after verifying the wiring.

Er26-d - Duplicate Synchronization Signal

Possible cause:
A synchronization signal may be received from an external source while another synchronization signal is also being generated by a slave station, causing a conflict.

Checks and solutions:
Review the CANopen network configuration and make sure there is only one synchronization-signal source in the communication network.

Er26-e - Bus Load Too High

Possible cause:
In asynchronous operation mode, the number of frames received by the slave station may exceed the communication capacity available at the configured baud rate.

Checks and solutions:
Increase the data-frame transmission interval from the master station. Check and, if necessary, change the slave station's TPDO transmission mode. Adjust the CANopen baud rate to suit the network load.

Er26-f - Parameter Modification State Error

Possible cause:
A parameter change may have been attempted while the CANopen device was in a state that does not permit that modification.

Checks and solutions:
According to the source information, set the CANopen state machine to Pre-OP or OP, then retry the parameter modification.

INVT DA200 Fault Code Document

+ INVT DA200 Servo Fault Codes (PDF)

Related INVT Servo Pages

+ INVT DA200 Servo Fault Code Index

+ INVT Servo Manuals and Documents

+ INVT Servo Systems

+ INVT Main Page