Fuji Servo Systems
Fuji servo systems: motor, amplifier and feedback
A servo amplifier commands the motor, while an encoder reports movement back to the controller. Accurate position, speed or torque control depends on matching these components. Motor power or amplifier series alone can hide important cable and feedback differences. Fuji servo generations are separated here.
Where do the generations differ?
ALPHA7 describes a later family, while ALPHA5 covers the previous generation. In older families such as FALDIC-W, amplifier and motor codes must be matched separately. Motors of similar torque can still differ in encoder, shaft, brake or connector, affecting both mounting and cabling.
Before replacing an axis
Record the motor plate, amplifier code, encoder type, brake supply, power cable and feedback cable separately. The PLC’s motion command may use pulses, a network or an analog signal; a replacement drive must support the actual method. See Fuji PLC for the control side and servo software for setup tools.
Manual titles are grouped in servo documents. Discontinuation of an older model does not mean every motor is compatible with the next family.