6ES7 138-4FB01-0AB0
6ES7 138-4FB01-0AB0 — Siemens ET 200S 4 F-DO PROFIsafe Output Module
6ES7 138-4FB01-0AB0 is a four-channel fail-safe digital output module for ET 200S in the Siemens industrial automation range. Its designation is 4 F-DO DC 24 V / 2 A PROFIsafe. Within the Siemens ET 200 distributed I/O family, it transfers output commands from the safety program to suitable field loads.
Function and output arrangement
The module provides four fail-safe outputs rated at 24 V DC and 2 A per channel. Its P/M switching arrangement controls both the positive and negative sides of the load. Wiring intended for a conventional PNP output should therefore not be transferred unchanged. In industrial automation applications, load wiring, power distribution and safety circuit design must be considered together.
Siemens application examples use this model with a CPU 315F-2 DP and IM151-1 High Feature. For functions such as emergency stop and guard-door monitoring, the safety program makes the decision and the F-DO module acts on the output side. In SIMATIC S7 control systems, it does not replace a standalone safety relay or an F-CPU.
Five checks before selection or replacement
1. Complete order number: Compare the label's 6ES7 138-4FB01-0AB0 code with the project record. Do not treat 4FB02, 4FB03 or 4FB04 versions as equivalent based on appearance alone. Within the ET 200 system architecture, mechanical fit, communication compatibility and software support require separate checks.
2. Terminal module: A Siemens example containing this model uses the TM-E30C46-A1, 6ES7 193-4CF50-0AA0 terminal module. This is a documented pairing, not a statement that it is the only option. Check the installed base's code and wiring diagram. The electronic module and terminal module are separate components.
3. Connected load: Review operating current, inrush current and the connection arrangement. The 2 A channel rating does not establish suitability for every load under every condition. Preserve the required P/M output arrangement when modifying existing wiring.
4. Controller and project: Assess the PLC control architecture, station interface, F-CPU and hardware-catalog selection together. The PROFIsafe designation alone does not establish compatibility with every PROFINET station.
5. Safety parameters: Review the PROFIsafe address, F-monitoring time, channel readback times and wire-break diagnostics. Siemens documents a separately configurable readback time for each output. Alarm messages on HMI operator panels should identify the affected channel and load to support troubleshooting.
Troubleshooting and documentation
Check power supply, load circuit, channel diagnostics and safety communication separately when investigating a fault. Event chronology in SCADA monitoring systems can help, but a cleared alarm does not validate the safety function. Use the Siemens ET 200 PDF manuals page to access the relevant wiring and configuration documentation.
Editor's note: Siemens identifies this model for safety applications up to SIL 3. Installing the module alone does not establish that level: the controller, safety program, load circuit and system validation must be assessed together. For replacement work, matching the complete order number to the existing project is the priority. A basic output test does not replace acceptance testing of the machine's safety function.
For product assessment, provide the complete model, quantity, operating or fault condition and a label photograph through our technical contact for Siemens products page. Including the terminal module code helps avoid an incomplete assembly or incorrect pairing.
Related topics and Siemens navigation
Product families
Siemens main menu |
Siemens PLC products |
SIMATIC S7
ET 200 resources
ET 200 products |
ET 200 system information |
ET 200 PDF manuals
Control and support
HMI operator panels |
SCADA systems |
Contact for Siemens products