6ES7 138-4DJ00-0AB0
Siemens main menu › SIMATIC S7 › SIMATIC ET 200
Siemens 6ES7 138-4DJ00-0AB0 — ET 200S 1PosInc/Analog Positioning Module
6ES7 138-4DJ00-0AB0 is the 1PosInc/Analog single-axis positioning module for the ET 200S series within the Siemens ET 200 distributed I/O family. It receives position feedback from an incremental encoder and commands the drive through an analog reference. Among ET 200 special-function and additional modules, it serves an axis-positioning role.
Order number: 6ES7138-4DJ00-0AB0
Function: 1PosInc/Analog
Encoder interface: 5 V differential incremental signals, RS-422
Drive command: ±10 V, or 0–10 V with a digital direction signal
Module width: 30 mm
Its role in the station
Within the ET 200 system architecture, this module manages the change from rapid to creep feed and the switch-off point as the axis approaches its target. An external drive supplies motor power. Before ordering, examine the drive command interface and encoder label alongside the PLC hardware.
Distinguish 5 V signals from encoder supply voltage
A 5 V differential interface does not imply a 5 V supply output. The Siemens terminal table identifies the encoder supply connection as 24 V DC. Verify the encoder's supply requirement and output signal type separately. These are different specifications when checking ET 200 power supply modules and the ET 200 power distribution arrangement.
Five checks before ordering
1. Encoder compatibility: Record the full encoder code, signal type, pulse count and supply requirement. “An encoder is fitted” is not enough information. Photographing conductor assignments and shield connections helps prevent wiring mistakes during replacement.
2. Drive interface: Compare the drive's analog reference range and direction control requirements. Establish which physical direction corresponds to each command in the project. Standard ET 200 digital output modules alone do not provide this module's analog reference function.
3. Station and software: Check the complete order number of the ET 200 communication interface, the software version and the configured module. Back up the parameters and control program. A different positioning module with the same housing does not establish program compatibility.
4. Base and field wiring: Treat ET 200 terminal blocks and electronic modules as separate components. When reviewing ET 200 connection modules, compare the full base code, contact condition and terminal numbering. Trace limit and reference signals against the cabinet schematic without confusing them with addresses assigned to other ET 200 digital input modules.
5. Mechanics and stopping: Assess drive settings, changing loads, mechanical backlash and braking behaviour. Verify positioning and machine safety functions separately. Select any required ET 200 safety modules and stopping arrangements according to the machine's safety design.
Cabling and commissioning note
Siemens product information specifies up to 50 m of shielded cable for encoder signals and up to 100 m of shielded cable for the analog output. These limits do not replace the shielding and connection requirements. Following replacement, complete direction, reference and stopping checks under controlled conditions before returning to normal production.
Editor's note
Include the module, encoder and drive labels together in a spare-part enquiry. Avoid describing the encoder only as “5 V”; state whether this refers to its signals or its power supply. Correct selection depends on electrical and functional compatibility between all three components.
Manuals and PDF documentation
On our Siemens ET 200 PDF and user manuals page, use ET 200S Positioning, A5E00124871-04, chapter 4 — 1PosInc/Analog. Refer to section 4.3 for connections, 4.6 for operating functions and 4.10 for technical limits.
Related topics and Siemens navigation
Product family: Siemens main menu | SIMATIC S7 | ET 200 family
Station and connections: Special and additional modules | Terminal blocks | PROFIBUS and PROFINET
Technical resources: About ET 200 | Power supply modules | ET 200 PDF manuals