6ES7 132-0BH00-0XB0
Siemens 6ES7132-0BH00-0XB0 ET 200B 16-Channel Digital Output Module
6ES7132-0BH00-0XB0 is a 24 V DC, 16-channel digital output electronic block in the SIMATIC ET 200B family. Its output arrangement is 12 × 0.5 A and 4 × 2 A. Part of the Siemens industrial automation range, it controls suitable valve and contactor coils.
Within the Siemens ET 200 distributed I/O family, this model belongs to ET 200B. When selecting replacements for industrial automation applications, read the complete order number; do not treat 0BH00, 0BH01 and 1BH00 as interchangeable simply because their codes look similar.
Which outputs support 2 A?
Q0.0, Q0.1, Q1.0 and Q1.1 support 2 A, while Q0.2–Q0.7 and Q1.2–Q1.7 support 0.5 A. The combined load limit is nevertheless 4 A for each of the Q0 and Q1 groups. In PLC-based control applications, build the load schedule around more than channel count: record the output assigned to each coil and identify which loads operate together.
Five checks before selection or replacement
1. Terminal base: Compatible bases are TB1/DC, TB1-4/DC and TB3/DC. When reviewing ET 200 system architecture and terminal selection, compare the base type, terminal arrangement and existing wiring. The electronic block and terminal base labels identify different components; record both when documenting a replacement.
2. Load and electronics supplies: L1+ supplies Q0, L2+ supplies Q1, and L3+ supplies the internal electronics; these positive supply lines are not internally connected. If one group does not operate, measure its supply under load. Continuing communication does not establish that every load supply is healthy.
3. Communication and station selection: The product operates on PROFIBUS DP. Siemens' COM PROFIBUS example lists the complete order number as a B-16DO DP station. In SIMATIC S7 control systems or other existing DP master configurations, compare the station address, device definition and output addresses with the project backup. Before replacing components in the Siemens PLC and I/O range, record the working project's settings.
4. Load operating conditions: Assess coil energization behavior as well as continuous current. Calculate channel and group currents separately, and examine cable voltage drop and other loads sharing the supply. Do not move a higher-current coil to any available output; the selected channel must have sufficient capacity.
5. Fault indication: BF helps assess communication faults, while DIA indicates group faults such as short circuits or loss of load voltage. Review commands on HMI operator panels alongside field feedback. A useful fault record includes the affected outputs, LED states and measured supply voltages, rather than only “module not working”.
PDF manuals and selecting the correct revision
Use the Siemens ET 200 PDF manuals page for documentation resources. The exact 0BH00 model is covered in Section 8.1.6 of ET 200B Distributed I/O Station, EWA 4NEB 812 6089-02b. Share the label photograph, terminal type and load schedule through Siemens product technical enquiries.
Editor's note: Running both 2 A outputs in one group at full load reaches the 4 A group limit. Having six physically unused outputs does not mean that additional current capacity remains in that group. Before commissioning, check the simultaneous load combinations that the program can activate.
Related topics and Siemens navigation
Product families
Siemens main menu |
Siemens PLC products |
SIMATIC S7
ET 200 resources
ET 200 products |
ET 200 system overview |
ET 200 PDF manuals
Control and assistance
HMI operator panels |
SCADA systems |
Siemens product enquiries