Delta DVP memory accessories

Delta DVP memory accessories

Delta DVP memory accessories are hardware products for backing up, copying and restoring programs and associated data on supported PLC models. The principal products in this category, DVP-512FM and DVPPCC01, use different connections and operating procedures. Check the complete CPU code, firmware version, data areas to be transferred and restoration method together.

DVP-512FM: backup card for the EH3 family

Delta DVP-512FM is a data backup memory card used with the Delta DVP-EH3 family. The ISPSoft manual shows its status under Data Backup Memory Card in Connected Information. Transfers distinguish PLC memory → card from card → PLC memory.

DVP-256FM is the earlier card associated with Delta DVP-EH2; the catalogue lists DVP-E64FM for Delta DVP-ES2. These names do not establish interchangeability with DVP-512FM. A backup card should not be treated as a general-purpose RAM module that increases CPU working memory.

DVPPCC01: program copying through the COM port

Delta DVPPCC01 is listed as a 64k-word backup accessory. It connects to the PLC's COM port: RD reads from the PLC into the accessory, while WR writes from the accessory into the PLC. The manual requires STOP status for writing and uses the OK LED to indicate completion.

The 2013 manual's section 11.1 lists 4k program steps for DVP-ES, DVP-EX and DVP-SS; 8k for DVP-SA/SX/SC; and 16k for EH/EH2/SV. Data areas also vary by model. This scope must not be extended to every subsequent DVP generation: 64k-word card storage does not mean that every CPU supports copying a 64k-step program.

Backup scope and software

Check programs, parameters, retained data and password conditions separately. A copy on a card does not prove that the complete, commented computer project has also been preserved. Keep the editable machine project, version details and commissioning notes separately.

Select Delta WPLSoft or Delta ISPSoft according to CPU support; review their scope under Delta PLC software. For computer-based backups, match Delta DVP programming cables and Delta DVP communication cables to the correct port. A cable, software package and memory accessory perform different tasks.

Start document selection at Delta PLC accessories files. Section 21.1 of the ISPSoft User Manual covers memory-card backup and restoration; chapter 11 of the DVP-PLC Application Manual — Special Modules covers DVPPCC01. Identify the CPU family through Delta DVP PLC series.

Editor's Note

First establish which machine the stored copy belongs to. Label the accessory with the CPU code, machine, project date and revision. An unlabelled card from a drawer may work perfectly and still contain the wrong backup.

Keep RD and WR directions clear. Reading can replace the card's existing copy; writing can replace the PLC's existing project. Identify the source and destination before starting, and keep the only available backup out of experimental tests.

Check more than the restored program. Keep a separate record for recipes, initial counter values, calibration data and machine-specific settings. A machine starting up does not establish that every production setting is correct.

Evaluate used accessories with a backup and restoration test. Use a suitable test CPU and a known project. An illuminated LED alone does not establish memory or transfer integrity; compare the content read back after restoration.

Inspect the slot and contacts. Install DVP-512FM with power disconnected, and follow the specific COM connection procedure for DVPPCC01. Check cracked housings, loose switches and oxidised contacts; keep the connection intact until transfer finishes.

Related topics

Review other supporting hardware under Delta PLC accessories and controller or module families under Delta PLC. Use Delta PLC and HMI manuals for model documentation.

External references: Delta ISPSoft User Manual — 2021, English · Delta DVP Special Modules Manual — 2013, English · Delta DVP/TP Catalogue — 2024, English.


Refine Search