Delta AS-FEN02

Delta AS-FEN02 Ethernet function card

The Delta AS-FEN02 is a dual-RJ45 Ethernet function card for Delta AS300 CPUs. It supports Modbus TCP Client/Server and EtherNet/IP Adapter. The card uses its own Ethernet interface and leaves the CPU’s built-in Ethernet port available.

CPU, slot and firmware

Delta specifies AS300 CPU firmware V1.06 or later and ISPSoft V3.06 or later. Check the physical card slot and project settings against the full CPU model. See the AS300N-A for a CPU without built-in I/O and the AS320T-B, AS320P-B, AS332T-A, AS332P-A and AS324MT-A for models with built-in I/O.

The card also fits the AS00SCM-A module running firmware V2.02 or later. In this configuration, the AS00SCM-A operates in RTU mode as an Ethernet remote I/O station.

Ethernet ports and protocol selection

X1 and X2 are switched 10/100BASE‑TX ports. They support line or star connections on the same Ethernet network. Delta specifies Auto MDI/MDIX and CAT5e up to 100 m per link. See Delta PLC cables when selecting a cable for the port.

In Modbus TCP, the Client starts the request and the Server responds. For EtherNet/IP, the card acts as the Adapter and a Scanner on the network initiates data exchange. See the AS-FPFN02 for PROFINET Device, AS-FCOPM for CANopen, AS-F485 for RS‑485 and AS-F232 for RS‑232.

Card setup in ISPSoft

In an AS300 project, set the card’s IP address and subnet mask in ISPSoft under HWCONFIG → Function Card 2 Setting → Ethernet Port Basic Setting. The host CPU or AS00SCM-A stores the card parameters. Use COMMGR to check the connection and see Delta PLC software for software selection.

Editor’s Note

On a used card, inspect the AS-FEN02 label, sockets and both retaining clips.
Switch off power to the CPU or RTU before fitting or removing the card.
Record the existing IP address, subnet mask and data mapping before replacement.
On the bench, check the X1 and X2 LINK/ACT indicators separately with a known-good cable.
Finish by reading a test value over Modbus TCP or EtherNet/IP.

PDFs and related topics

See our Delta PLC and HMI manuals. Delta’s module manual covers AS-FEN02 in Section 10.2.7 and AS00SCM-A remote I/O in Chapter 9.

AS expansion modules · Delta AS PLC series · Delta PLC · Used Delta products

External references · AS hardware and operation manual (EN) · AS module manual (EN) · Communication card installation sheet (TR/EN)