FC51 fault codes

Hi everyone,
This passage describes how warnings and alarms are indicated and what actions can be taken to reset them. A warning is indicated by an LED and a code on the display, and remains active until the cause is resolved. An alarm results in the frequency converter tripping and requires resetting once the cause has been rectified. Alarms can be reset in four ways, including via a manual reset, digital input, or serial communication.
If an alarm cannot be reset, it may be trip-locked, in which case the mains supply must be switched off before it can be reset. Table 6.1 provides codes for warnings and alarms, and in some cases, it can specify whether a warning or alarm is to be displayed. After an alarm or trip, the motor coasts and both the warning and alarm flash. Once the problem is resolved, only the alarm continues flashing.
AL 2: Live zero error . detail >>
AL 4: Mains phase loss . detail >>
AL 7: DC over voltage . detail >>
AL 8: DC under voltage . detail >>
AL 9: Inverter overloaded . detail >>
AL 10: Motor ETR overtemperature. detail >>
AL 11: Motor thermistor overtemperature. detail >>
AL 12: Torque limit . detail >>
AL 13: Overcurrent . detail >>
AL 14: Ground fault . detail >>
AL 16: Short circuit . detail >>
AL 17: Control word timeout . detail >>
AL 25: Brake resistor short-circuited . detail >>
AL 27: Brake chopper short-circuited . detail >>
AL 28: Brake check . detail >>
AL 29: Power board over temp . detail >>
AL 30: Motor phase U missing . detail >>
AL 31: Motor phase V missing . detail >>
AL 32: Motor phase W missing . detail >>
AL 38: Internal fault . detail >>
AL 44: Ground fault . detail >>
AL 47: Control voltage fault . detail >>
AL 51: AMA check Unom and Inom . detail >>
AL 52: AMA low Inom . detail >>
AL 59: Current limit . detail >>
AL 63: Mechanical brake low . detail >>
AL 80: Frequency converter initialized to default value . detail >>
AL 84: The connection between frequency converter and LCP is lost . detail >>
AL 85: Key disabled . detail >>
AL 86: Copy fail . detail >>
AL 87: LCP data invalid . detail >>
AL 88: LCP data not compatible . detail >>
AL 89: Parameter read only . detail >>
AL 90: Parameter database busy . detail >>
AL 91: Parameter value is not valid in this mode . detail >>
AL 92: Parameter value exceeds the minimum/maximum limits. detail >>
Err: A wrong password was entered . detail >>
+
+ Danfoss FC 51 Micro User Manual
+ FC51 Fault Codes >>
+ FC51 Fault Codes 1 >>
+ FC51 Fault Codes 2 >>
+ Danfoss Main Page (2) >>
+ VFD Home page >>