Machinery and Process Safety

What is machinery and process safety?
Machinery safety addresses risks from moving parts, crushing, cutting and other machine hazards. Process safety focuses on controlling events involving pressure, temperature, chemical reactions and releases of hazardous substances. Both disciplines can apply to the same installation: a mixer shaft presents a machinery hazard, while an uncontrolled temperature rise inside its tank presents a process hazard.
Two different safety questions in one installation
For the machine: Can an operator reach the rotating shaft? How long does hazardous movement continue after the guard opens? These questions bring together ISO 12100, risk assessment and risk reduction and machine safeguards. ISO 14120 addresses guard design, while ISO 14119 addresses interlocking devices associated with guards.
For the process: What happens if cooling fails? Could a feed valve stuck open cause excessive pressure? Could a release affect nearby equipment? The objective includes preventing a hazardous event or limiting its escalation. IEC 61511 is a central reference for safety instrumented systems in the process industry.
Do not place the entire safety burden on the control system
Machinery risk reduction starts with inherently safe design, followed by safeguarding and protective measures, then information for use addressing remaining risks. Labels and training cannot replace a practicable physical safeguard. Safety distances that prevent reaching hazards and safeguard positioning address different questions: preventing physical reach and coordinating detection with the time needed to stop hazardous movement.
Choosing a safety light curtain requires more than checking its detection resolution. Consider overall response time, machine stopping time, approach routes and ways of bypassing the detection zone. IEC 62046 also provides guidance on applying protective equipment to machinery.
Functional safety: detect, decide and act
Functional safety depends on the relevant systems correctly performing the required safety behaviour. A typical chain comprises sensor → logic solver → final element. The final element might be a contactor, an appropriate drive safety function or a process valve. A working sensor does not, by itself, demonstrate that the final element will respond correctly.
ISO 13849 and IEC 62061 provide major frameworks for machinery safety-related control systems. IEC 61508 provides the general functional safety framework, while IEC 61511 addresses its application in the process sector. IEC TS 63394 offers supplementary guidance for machinery safety-related control systems.
PL and SIL are not overall safety scores for an entire machine. The required target relates to a defined safety function and its necessary risk reduction. PFDavg is used for low-demand operation, whereas PFH is used for high-demand or continuous operation. These measures are not interchangeable, and a component certificate does not establish the adequacy of the complete safety chain.
A safe state does not always mean switching everything off
Illustrative scenario: Opening the guard of a heated mixing tank may require accessible hazardous movement to stop safely. However, shutting down cooling at the same time could allow the contents to reach a dangerous temperature. Consequently, which movement stops, which position each valve assumes and which supporting systems remain active must be determined by considering machinery and process risks together. This example illustrates the need to define the safe state for the application; it is not a control circuit specification.
Emergency stopping and energy isolation for maintenance serve different purposes. Releasing an emergency stop device must not automatically restart the machine. Maintenance also requires appropriate isolation and verification of electrical, pressure and stored energy sources.
Safety continues after commissioning
Verification, validation, periodic testing and management of change are parts of the safety lifecycle. The expected response to guard opening, sensor failure or loss of supporting utilities should be documented. For process safety functions, proof-test coverage and intervals matter: observing an alarm on a screen does not demonstrate that the complete chain has been tested. Remote access and software changes also require consideration of industrial cybersecurity.
External references
ISO 12100 · ISO 13849-1 · IEC 62061 · IEC 61511 · HSE — Functional safety · HSE — Control systems · HSE — Safe interventions · Pilz — Emergency stop reset
This page is a general technical guide. Application decisions require the complete relevant standards, sector-specific requirements and equipment documentation.