6ES7 195-1GG30-0XA0

Siemens main menu › SIMATIC S7 family › ET 200 › ET 200 manuals

6ES7 195-1GG30-0XA0 — Siemens ET 200M 620 mm Mounting Rail for Active Bus Modules

6ES7 195-1GG30-0XA0 is a 620 mm ET 200M mounting rail in the Siemens SIMATIC product family. It accommodates active bus modules in arrangements supporting module replacement during operation. When planning an ET 200 station layout, assess the overall rail length, usable mounting space and required bus bases together.

Five checks for selection and installation

1. Overall length and usable space: The rail is 620 mm long; Siemens specifies 580 mm of usable length for modules. When planning the Siemens S7 station arrangement, compare the combined widths of the power supply, interface and I/O modules with that space. Reserve room for future ET 200 additional components in the initial drawing. Rail length alone does not determine a fixed module count.

2. Active bus module compatibility: This is the special ET 200M rail profile used to accommodate active bus bases. When selecting ET 200 connection modules, check how the base locks into the rail and how adjacent bases connect. Include the bus base required by the ET 200 communication interface in the parts list. Keeping the rail, bus base and electronic module as separate order entries helps prevent missing components.

3. Fixing dimensions: The mounting drawing specifies a = 15 mm from the rail edge and b = 590 mm between fixing holes for the 620 mm rail. Mounting uses M6 screws. Compare the drawing references with the physical rail before drilling the panel. When replacing an existing rail, check the hole pattern separately from the overall length instead of assuming the old holes will fit.

4. Cabinet layout and grounding: Position the ET 200 power supply modules with cable ducts, ventilation and service access in mind. Keep ET 200 power distribution wiring from obstructing the installed modules. Make the rail’s protective-conductor connection according to the manufacturer’s installation drawing. On painted mounting surfaces, mechanical tightness alone does not establish suitable electrical contact.

5. Maintenance and system scope: Replacement during operation depends on suitable interfaces, active bus bases and configuration. Check these conditions when planning maintenance for ET 200 function modules. Removing an active bus base requires it to be de-energized. The FF Link manual also lists this rail as an installation accessory. When reviewing ET 200 network interface options, follow the mechanical arrangement rules for the selected system.

Editor’s note

Keep three dimensions separate: 620 mm overall length, 580 mm usable module space and 590 mm between fixing holes. Treating them as a single “rail length” can lead to errors in the panel drawing. Check the order number before purchasing, then verify the drilling pattern and module arrangement before installation.

PDF and technical documentation

Visit the Siemens ET 200 PDF and user manual library for the documentation guide. In the ET 200M manual, 12/2008, EWA-4NEB780600602-08, page 42 covers usable lengths, pages 61–63 cover fixing and grounding, page 115 covers bus module replacement, and page 247 lists rail order numbers. Page 101 of the FF Link manual, A5E35651245-AB, also identifies the 620 mm rail.

Related topics

Terminal bases • Connection modules • Communication interfaces • Other network interfaces • Power distribution • Additional modules

Otomasyon AVM • Siemens guide

Siemens main menu  |  SIMATIC S7 family  |  ET 200 module categories  |  ET 200 PDF archive