6ES7 194-3AA00-0AA0
Siemens 6ES7194-3AA00-0AA0 ET 200eco ECOFAST Terminal Block
6ES7194-3AA00-0AA0 is a PROFIBUS DP terminal block with two ECOFAST connections for SIMATIC ET 200eco stations. Within the Siemens industrial automation range, its hybrid cable arrangement carries RS485 communication and power supplies. In Siemens ET 200 distributed I/O systems, this component provides the fieldbus and power connections for the ET 200eco I/O module.
X01 is the incoming connection and X02 continues to the next station. An internal T connection links the incoming and outgoing PROFIBUS DP and supply circuits. Dimensions are 79 × 60 × 30 mm (width × height × depth). The data sheet lists a typical power loss of 2 W, dependent on the current passed through the block. For machine and process automation applications, recording cable directions and station order helps trace connection faults in PLC based control systems.
Five checks before selection or maintenance
1. Connection type and complete code: 6ES7194-3AA00-0AA0 is the ECOFAST version. The similarly numbered 6ES7194-3AA00-0BA0 uses M12 and 7/8″ connections. When checking ET 200 system architecture and module compatibility, compare the final order code group, installed cable connectors and I/O module label. The “3AA00” portion alone is insufficient to identify the connection arrangement.
2. PROFIBUS address: Set an address from 1 to 99 using the DIL switches in the configuration connector. Confirm that the address is unique on the network and matches the station address in the SIMATIC S7 control system project. An address change takes effect after power is cycled. Photograph the switch settings before removal and read the actual settings again after replacement instead of relying on an old maintenance label.
3. Supply current and voltage drop: Maximum feed current is 8 A on the 1L+ electronics/sensor supply and 10 A on the 2L+ load supply. Include loads passed to subsequent stations in the calculation. On long cable runs serving Siemens PLC and I/O products, check conductor cross-section and the voltage at the final station under load. When several stations show faults together, inspect their shared supply route as well.
4. Bus termination: Each PROFIBUS segment requires suitable termination at both ends. Use an ECOFAST terminating resistor at the final ET 200eco station. A protective cap does not provide bus termination. If the line has been extended, identify the new final station and check the termination arrangement against the revised layout.
5. Latches, seals and replacement: Inspect connector coding, latches and sealing surfaces; close unused sockets with suitable caps. Do not disconnect an ECOFAST connector during operation. Switch off the 2L+ load supply before removal and follow the plant's safe shutdown procedure. After the work, review station diagnostics and HMI operator panel alarm records.
PDF manuals and wiring diagrams
Visit the Siemens ET 200 PDF manuals page for relevant documentation. In the ET 200eco operating instructions, section 2.6 covers address settings, section 3.4.5 covers ECOFAST wiring and section 8.2 provides the terminal block specifications. Match pin assignments and installation details to the complete device code. Share photographs of the label, configuration connector and cable connections through the Siemens product technical contact page.
Editor's note: Check the terminal block, address configuration connector and bus terminator separately when preparing spare parts. Even with the correct block, a missing configuration connector or a terminator left in the wrong position can delay commissioning.
Related topics and Siemens navigation
Product families
Siemens main menu |
Siemens PLC products |
SIMATIC S7
ET 200 resources
ET 200 products |
ET 200 system overview |
ET 200 PDF manuals
Control and assistance
HMI operator panels |
SCADA systems |
Siemens product enquiries